Customers compare PLR158-102-SS to these similar products
Products Featured in this Video
Jake: Hey guys, Jake here at Etrailer. Today I'm going to show you how to replace your hasp on your enclosed trailer. This hasp is going to come in three different varieties. It's going to come in a zinc-plated steel, like we have here, aluminum and stainless steel. This is one part on your trailer that's often forgotten about for example this is… see more >
Info for these parts were:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
To replace the 160019 touchpad you'd need the #LC421484 but we do not have the other parts you mentioned.
view full answer...To replace the Level Up controller on your 2012 Dutchmen Infinity 3750FL you need the Replacement OneControl Advantage Controller #LC88TF. I confirmed this is what you're needing with my contact at Lippert!
view full answer...To clear an error from the Control Panel for Lippert Ground Control #LC421484 you must repair the error and simply press the enter key on the control panel. If the same message is still displayed the error has not been repaired. If you can tell me…
view full answer...It sounds like you're looking for the Replacement Quick Level Touch Panel for Lippert Components Level-Up Hydraulic Leveling System #LC74FR which works with the Level-Up system. This is the touch pad "controller" but if you are looking…
view full answer...It sounds like it yes but first, I recommend unplugging it from power and let it sit for about 15 minutes. This is going to hard reset the panel and hopefully fix the issues. You're going to also want to make sure that the connectors are clean…
view full answer...It's likely you have a blown fuse. There should be a 15 amp fuse that runs to the remote part #LC421484 as well as 35 amp fuses in the control module. Verify that all of the fuses are good as typically this is a blown fuses scenario.
view full answer...If you have the Lippert Ground Control Leveling system on your trailer the correct replacement module/display is the part #LC421484. Feel free to email me back with the pictures you have and I'll take a look though.
view full answer...The only pin that should be continuously showing 12V power on the 7-Way connector on your vehicle is the 12V power circuit which is normally the black wire but not always. In 7-way wiring the 12V auxiliary power feed is carried on the contact at the…
view full answer...The #BUL69CB LED Utility Light Bar you mentioned can be used for utility use or general illumination, but is not certified by the DOT for use as a back-up lamp as it would be too bright.
view full answer...The closest we have to the dimensions you mentioned is part #PLR158-102-A which measures 4-inches hole to hole. If that will not work for you and you have to drill a new hole for the hasp I recommend part #PLR158-102-SS. This measures 3-3/4 inches…
view full answer...The best thing to do to determine if this is the correct hasp for your 2000 Haulmark is to measure. I have linked an image with the measurements of the Polar Hasp #158-101 to this page for your convenience. The center on center mounting holes are…
view full answer...We offer two Paneloc lock hasps that are 1-1/2-inches wide, parts #H145-203E and #H135-203E, both of which are shown on the linked page. We also offer cam door latches like 2-inch #PLR158-102-A and #PLR158-102-SS, as well as 1-inch hasps like…
view full answer...