2014 Chevrolet Cruze Vehicle Lights

Yes, the 921 LED Bulbs #ARC48FR would be a compatible replacement for a JRP1007B light bulb. With this light being LED it will have a lower wattage and amperage draw for a cooler, brighter light that requires less energy to run.

We do offer teardrop style clearance lights in red, the Pacer Performance Hi-Five Truck Cab Light Kit part #PP20-215 which are sold as a set of five. These lights by law must be installed so that they face the rear of your vehicle. They come with…

The Vision X 9007 Halogen Headlight Bulbs with Relay Harness #VX-H9007-R uses a combination of 16 and 18 gauge wire. It may seem thin but with short distances like with this harness 16 and 18 gauge wires can actually handle a surprising amount of…

I recommend picking up the Durabilt Safety Chain Connectors for…

You are correct the hook ups are for the lights on the Blazer LED Cube Light Kit #BL28VR. The different ratings are for each of the circuits. The lights that come with the kit will fit onto the smaller connections allowing you to connect more…

The Vision X 9007 Halogen Headlight Bulbs with Relay Harness #VX-H9007-R will not effect your daytime running lights. This harness just bypasses the power draw from the headlight switch by pulling power directly from the car’s battery, which will…

The distinction…

Congrats on the new truck! To add an in bed 7-way connector to your 2023 Ram 3500, I recommend the Mighty Cord 5th Wheel/Gooseneck Wiring Harness w/ 7-Pole Connector item #A10-7007. This harness puts a 7-way connector in the bed of your truck and…

Hey Tom so I definitely know what you are asking for but due to the very minimalistic design of the Kuat Transfer part #KU84FR there…

Thanks for the axle information, Mike! Here are the correct parts according to my contact at Curt: - Bearing #02475 and Race #02420 - Bearing #25580 and Race #25520 - Grease Seals #RG06-070

If the lift motor will no longer operate with the controller but does when you apply direct 12 volt power then that tells me there is an issues with the control board. The only way to replace the control board on the Fan-Tastic Vent Roof Vent part…

Because the face of the magnet rides against the armature (inside) surface of the brake drum, any grooves that had previously been worn into the armature surface will cause the magnet to wear unevenly. For optimal braking performance, you want…