Hey Mike, thanks for reaching out! The Alpha Systems AlphaThane 5121 Self-Leveling Sealant #AL35KV is designed for wood, metal, and glass materials. Since your skylights are polycarbonate I recommend using the Specialty Recreation Skylight Sealant…
Hello again, James. I am afraid the answer will be the same as last time. We have no direct replacement for the Dexter #072-099-01 spring. The Dexter #DX23CR will be our closest option and this spring is 25-1/4" long. It can be used on your…
Hello Rocky, thanks for reaching out. If your new leaf springs do not have as much of an arch as the old springs they are definitely not going to help your situation if your tires are already rubbing on the fenders. What we would usually do here is…
To replace a skylight, you will follow the same installation as you would for a standard RV vent like #V2092SP-28. We do not have any skylight replacements available, but you will install a replacement using the Roof Vent Installation Kit - Sealant,…
The seal will push right on, but I would recommend using a few dots of adhesive to secure the seal in place. I would not recommend using a super glue, as it can melt plastics and weld things together. A few small dabs of silicone sealant would be…
I have attached for you below some common torque values needed for a trailer suspension system but a lot of these will vary by bolt size and other factors. U-Bolts: Varies by Size - 1/2" bolts: 45 ft/lbs - 70 ft/lbs, 9/16" bolts: 65 ft/lbs…
Since Grand Design is kind enough to list certain parts for their trailers I can confirm you have a 33" wheelbase on your 2020 Grand Design Transcend 27BHS. This means the MORryde Rubber Equalizers #MR87ZR will fit your trailer. Although I'm…
You're looking for the Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Tandem Axle - 6,000 lbs #K71-652-00, which will fit on tandem axle trailers with 33" spacing between the axles (measured center on center of the axle-as you did).…
First you would want to jack up the trailer frame and then use jack stands to support it so that you can lower the jack and the wheels will be off of the ground. Next you will want to slide the jack under the first axle so that you can raise it up to…
You can change out your springs to higher-rated ones but that will not increase the trailer's weight carrying capacity. It will likely give you a stiffer ride, which you may or may not prefer. Chances are good that your trailer spring broke…
According to my LaSalle/Bristol representative, neither the valve size itself nor the spacing of the holes for the mounting hardware have changed over the years. The mounting holes are 3.73 inches apart center to center, which is right between 2-5/8…
The Lippert Components Standard Axle Lift Kit part #LC425750 is compatible with any trailer that uses standard leaf spring axles whether it's made by Lippert or Dexter. The kit is designed for single axle applications.
