Yes, the arms of the Roadmaster Falcon 2 Tow Bar #RM-520 will extend and lock into position when you start pulling your vehicle. The bars can often be difficult to release when you go to disconnect the tow bars from the towed vehicle when you get to…
We have everything you need to pull your new GMC Terrain or Chevy Equinox behind your RV with all 4 wheels on the ground. To do this you will need a base plate kit, a tow bar, safety cables, a lighting solution, and a supplemental braking system.…
For the 2016 Chevy Equinox the correct 4-way harness is the part #118264 or Curt part #C56210. These will attach to the factory trailer wiring port in the rear of the vehicle. I attached pictures that show you where to find the port at the rear of…
What you can do is use a bolt leader like #80101-1 with a carriage bolt block through an open portion of your frame to basically act as a weld nut so you can install the hitch. This normally is a solution we use when a vehicle has a broken weld nut…
What we can do is provide you with the bolt size that is used to install the part #36408 that you referenced and you can find a tap at a local hardware store to clean the threads out if you think they are too corroded. The bolt size is M12 CL8.8. I…
You can carry a women's bike on the Yakima FullBack 2 Bike Rack #Y02634 using a bike adapter bar like the #Y02531. This will allow the bike to sit level on the arms of the FullBack and attaches between the seat post and handlebar post.
We do have some demonstration videos. I have included a link below to a video demonstrating the Yakima bike frame adapter, part #Y02531, with a similar Yakima bike rack. The video explains and shows how the adapter is installed.
The ramp for the Hollywood Racks Destination E Bike Rack #HLY66ZR does not mount on the rack and would need to be carried in your vehicle. It can extend up to 46" long as it telescopes.
If your 2015 Chevrolet Equinox has a factory tow package, there should be a trailer connector at the rear of the vehicle, behind the rear bumper. The connector could also be inside a black box that is mounted under the vehicle. If this is present,…
All you need is to get at least 4 to 8 inches of overhang on the side you're planning on putting the hullavator #TH898. That being said, you can offset the Airflow 2 #MPG217 to one side to get that overhang at least on one side. I recommend doing…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
Yes, the Thule Hullavator Pro Kayak Carrier part #TH898 will work with the Malone AirFlow2 Roof Rack either using the integrated channels or the wrap-around style clamps. However, the Hullavator requires that the crossbars extend at least 4"…
