Hey David, the box on the top of the High Pointe Microwave part #HP59ZR that you referenced is the charcoal filter. This microwave does not have the ability to relocate this to the bottom of the microwave.
Since the trailer was off of the ground it would not take much voltage to stop the wheels from spinning so they may be getting power but they may not be getting enough power due to a short or wiring issue. But 9 times out of 10 weak trailer brakes…
I spoke to a Valterra representative and I was told that they do not offer a sleeve to slide over the two shafts to join them together. If the male thread has broken in the handle, and the coupler is still in working order, you may be able to use…
Parts #AKEBRK-35L and #AKEBRK-35R are left and right hand 10 inch brake assemblies for 3,500 pound trailer axles. Use #AKEBRK-35 to purchase both of them together. The hub and drum assemblies and the bearing kits are not included. A 3,500 pound axle…
That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…
