Videos
for Toyota Camry Owners
Help Articles
for Toyota Camry Owners
Expert Answers
for Toyota Camry Owners
It does sound like your converter box may be defective. Unfortunately, there is no way to reset the converter. I recommend trying to relocate the ground of the converter to see if this provides a solution to your problem. Grounding issues can show…
view full answer...I suspect your problem is caused by a damaged or corroded trailer connector. Take a look at your trailer connectors, both the socket on your truck as well as the plug on the trailer. Look for green or white corrosion on the pins or sockets of the…
view full answer...Sounds like you are looking for the replacement lock housing for Thule Snug Tite Hitch Locks part #753-3725-02.
view full answer...Although the Draw-Tite, #36416, and Hidden Hitch, #90152 (no longer available), trailer hitch receivers have a 300 lb tongue weight capacity and a 3500 lb towing capacity which would be sufficient for a trailer carrying 750 lbs, you are going to be…
view full answer...We have not yet replaced the Shock part #T1242600 on a Titan Model 10 Surge Brake Actuator so I do not have any specifics for you but I have attached a parts diagram which shows you how the unit is broken down. You can then use this to get a better…
view full answer...In order to determine if we have an axle that would bolt right up to what you have without welding we need to know the distance between your spring seats on center. We also need to know hub face to hub face dimension of your current axle as well.
view full answer...The Brophy D-Ring Tie Down Anchor w Backing Plate - Bolt-On - 1/2" Wide - Recessed - 1,600 lbs #RR5K are rated for 5,000 lbs break strength and will work just fine with your application. The 3/4 inch plywood floor is very strong and with the…
view full answer...The Dexter Trailer Idler Axle w/ Hubs - EZ-Lube - 5 on 4-1/2 Bolt Pattern - 60" Long - 2,200 lbs #20545I-EZ-60-15 is a great starting point to upgrade your trailer. This will give you a standard size axle with good bearings, hubs, and EZ-lube…
view full answer...I do have options for you but using receiver adapters reduce capacity. Instead, I recommend a cargo carrier with a built-in rise like the 24x60 etrailer Cargo Carrier for 2" Hitches part #e98874 which is better suited for low ground clearance…
view full answer...The Karrite Voyager was a distant relative to the current Thule Sidekick Cargo Box #TH78GC. The box uses standard U-bolt hardware to attach to roof rack crossbars and tightens down with the included plates and threaded knobs. I have attached the…
view full answer...Your Thule Gateway Pro 3 will have a Fit Dial setting of 9 for your 2003 Volvo V70. These are the fit notes. 101. Place top clips in the gap at the front edge of the top of the trunk, hatch , or door. 102. Place lower clips in the bottom edge of…
view full answer...The Draw Tite Hitch part number 02203 has been long since discontinued. Back in its day it was confirmed to fit 1985 to 1991 midsize trucks from Chevy, Dodge and Ford. That's as specific of fit information that I was able to track down.
view full answer...