Custom Fit 2007 Jeep Grand Cherokee Accessories

I have a couple of wiring harnesses that will add a 7-way and a 4-flat to your 2007 Jeep Grand Cherokee. However, since you do not have the towing package the 7-way harness is going to need to be wired in. The first wiring harness you will need is…

Each of the hitches you mentioned, the Curt #13251 and Draw-Tite #75338 will fit a 2007 Jeep Grand Cherokee Laredo; the only models they will not fit are the SRT-8. I recommend going with the Draw-Tite #75338 because it has a tongue weight capacity…

First let's start with a base plate kit. For that I would recommend the Roadmaster Base Plate #1427-1. This is the most popular option we have for your vehicle and I attached an install video for you to check out as well. In addition to the…

There isn't a required fitting to install a transmission cooler in a 2007 Jeep Grand Cherokee with the 3.7 liter motor. Transmission coolers such as #D13503 come with an Insta-dapt fitting which fits most Jeep Grand Cherokees with…

The 2007 Jeep Grand Cherokee does not have the pre-wired port used for installation of a brake controller. To install a brake controller on your 2007 Jeep Grand Cherokee with a factory 7-Way you will need to do some hard wiring. The wire Jeep…

If you have a 2009 or newer Yakima Skybox 16, then you can simply use Replacement SuperLatch Handles #Y8880348. If you don't have 2009+ wing-style latch then unfortunately there are no replacement latches for it. Yakima also does not make…

Yes, the Curt Class I Trailer Hitch Receiver #C11103 is a confirmed fit on the 2007 Jeep Grand Cherokee SRT8 with center-positioned dual exhaust. I confirmed compatibility with Curt's fit guide and also with one of their technicians. The…

I have attached a picture of the CURT Front Mount Trailer Hitch Receiver, #C31047, installed on a Jeep Grand Cherokee. The hitch does not install all the way below the air dam. The air dam will actually be removed and then reinstalled after hitch…

The most popular hitch receiver for your 2007 Jeep Grand Cherokee Laredo is the 2-inch Class III hitch #13251 from Curt. This installs without drilling, as do all other available hitches that you can see on the linked page. This hitch fits all GC…

Normally you can find the brake light switch under the dashboard at the top of the brake pedal. There could be a number of wires attached to the switch so you can use a tester like part #PTW2993 to test the wires. Since the auto manufacturers can…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

You are correct that there is a green wire exiting the brake controller connector under the dash of your 2005 Jeep Grand Cherokee. The problem is that since your vehicle is not equipped with the tow package the wire is terminated somewhere inside…