Trunk Bike Racks Specs:
Features:
...Quick-release hubs ensure optimal arm angle and a proper fit to your trunk Also allow arms to fold down for compact storage 6 Cam-buckle straps with rubber-coated hooks secure rack to your vehicle Rubber foot...
More Information >Trunk Bike Racks Specs:
Features:
...Trunk bike rack carries 2 bikes using the rear of your vehicle Easy-to-use Fit Dial system adjusts rack base to fit your vehicle Installs with 6 attachment straps Dual support arms provide...
Installation Notes:
Place top clips in the gap at the front edge of the top of the trunk, hatch or door
Set lower clips/hooks into vehicle's left and right tow loops under the rear of the vehicle.
Caution: The trunk lid may deform slightly with the use of this carrier. Remove carrier when not in use.
Thule cannot recommend the use of 3-bike carriers on this vehicle.
Lower arm of carrier will rest in the bottom of the license plate well.
More Information >Trunk Bike Racks Specs:
Features:
...not in use Integrated cable lock secures bikes to rack Locking strap (sold separately) secures rack to vehicle 6 Nylon straps with hooks and cam buckles anchor the rack to your vehicle Holders...
Installation Notes:
Place top clips in the gap at the front edge of the top of the trunk, hatch or door
Set lower clips/hooks into vehicle's left and right tow loops under the rear of the vehicle.
Caution: The trunk lid may deform slightly with the use of this carrier. Remove carrier when not in use.
Thule cannot recommend the use of 3-bike carriers on this vehicle.
Lower arm of carrier will rest in the bottom of the license plate well.
More Information >Trunk Bike Racks Specs:
Features:
...of your trunk 6 Adjustable cam buckle straps with hooks anchor the rack to your trunk 4 Foam pads on rack base help protect your car's finish Rust-resistant, sturdy steel construction with black powder...
Installation Notes:
Use the tow loops on the side of the vehicle to attach straps or hooks.
Use the holes located in the vehicle frame for attaching hooks.
More Information >Videos
for Trunk Bike Racks
Help Articles
for Trunk Bike Racks
Expert Answers
for Trunk Bike Racks
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
view full answer...That is an excellent question and is asked more often than you think. Electric brakes like what come in the Electric Trailer Brake Kit #AKEBRK-2 can be submerged in water when you are loading/unloading your boat. Since water and electricity…
view full answer...The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…
view full answer...I'm assuming your Express doesn't have the 7-way, but does have the capped round plug behind the bumper on the drivers side frame rail,…
view full answer...You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…
view full answer...Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and…
view full answer...It really just depends on what the wires are for. Most likely you have several ground wires among the 8 as well as a couple running light circuits in there as well. You just have to run all of the wires to the correct circuits. The 4-way wiring of…
view full answer...A 4-way trailer connector will have four functions which means it will also have four wires for the exception of wishbone harnesses. These four functions are ground, tail light, right turn, and left turn. The ground function will usually be…
view full answer...The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the…
view full answer...I checked your order notes and the leaf springs you bought last year were the part #e28SR which are for 5k axles. Since this is over the capacity of your axle failure would not have been caused by over loading the trailer assuming you stayed under…
view full answer...The Dexter 072-078-00 is a 2,200 lb capacity leaf spring. You can use a higher capacity leaf spring, however it won't increase the capacity of your trailer as the axle is still rated for that max capacity of…
view full answer...Filter Products (8)
Contact and Help
What our customers are saying:
Very helpful/friendly Customer Service. Competitive Pricing. Shipping was Fast.
John
Mankato, MN