Select the correct transmission cooler by determining where there is enough space to mount it. The diagram on the left numbers the best three positions to mount the transmission cooler in order. Transmission coolers are more efficient when they receive maximum air flow. At Position 1, the transmission cooler is 100% efficient. Position 2, between the air conditioning condenser and radiator, is 75% efficient while Position 3, between the radiator and fan, is only 60% efficient. If positions 2 or 3 are used, a larger transmission cooler will be needed to compensate for the loss of cooling power. If this is the case, choose a transmission cooler that is one or two sizes larger.
Tech Tips: Transmission fluid cannot be over-cooled, but it is critical in extreme cold conditions to allow the vehicle to warm up before driving.
Transmission Coolers Specs:
Required Transmission Adapter Fitting:
Features:
11" Wide x 7-1/4" tall x 7/8" deep, efficient heat exchanger will prolong the life of your transmission and improve its overall performance. Specifically designed for vehicles with late-model, electronic overdrive transmissions.
Tech Tip:
Use kit # D13014 for 1/4" or 3/8" NPT trans-line type fittings, or use kit # D13024 for 1/2"-20 partial thread fittings.
More Information >Transmission Coolers Specs:
Required Transmission Adapter Fitting:
Features:
11" Wide x 7-1/4" tall x 7/8" deep, efficient heat exchanger will prolong the life of your transmission and improve its overall performance. Specifically designed for vehicles with late-model, electronic overdrive transmissions.
Tech Tip:
Use kit # D13014 for 1/4" or 3/8" NPT trans-line type fittings, or use kit # D13024 for 1/2"-20 partial thread fittings.
More Information >Videos
for Transmission Coolers
Help Articles
for Transmission Coolers
Expert Answers
for Transmission Coolers
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...You can install a stack cooler in your vehicle. The Class ratings are there as a reference point to a hitch Class. For example if someone has a Class III hitch they can look at coolers, see a Class III and say, hey, I have a Class III hitch so this…
view full answer...The method we use to determine the correct line to install a transmission cooler on is pretty simple. You want to install the cooler on the return line. To determine which line is the return line you will want to start with your truck totally…
view full answer...The good news is that 210 degrees isn't the worst temperature for…
view full answer...You are a little on the warm side for your transmission fluid. If you can keep it under 200 degrees you will have the max life out of it. That being said transmissions really start to go downhill at 260 degrees. The Derale cooler part #D13503 with…
view full answer...The Flex-a-lite Transmission Cooler #FLX400117 does come with everything needed to install. No other components would be needed.
view full answer...Given the weight of your trailer and the fact that you tow uphill I recommend going with the largest cooler or most efficient that will fit in the available space you have in the engine compartment of your 2004 Silverado. A stacked plate cooler is…
view full answer...Hey Jerry, the install of the Aries Bull Bar part #AAB35-4015 do require you to permanently remove the tow hooks to install. It looks like the similar Westin Ultimate Bull Bar part #32-3645 does allow you to keep them though.
view full answer...Thanks for the picture. Yes, it is. I checked with Furrion and the correct replacement for the F0S04TDE-RD/SY lights are the LED Marker Light RV Side Cameras w/ Night Vision for Furrion Vision S Systems item #FCE48TASL if you need the…
view full answer...Your 2014 Jeep Grand Cherokee is rated to tow 6,200 lbs as you stated. Your owners manual will state your trailer tongue weight should be approximately 10% of your total trailer weight. Most trailers are 10-15% tongue weight. You will want to make…
view full answer...For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…
view full answer...Filter Products (4)
Contact and Help
What our customers are saying:
In these days of customer "no service" I am usually disapointed when doing business with people I don't know. It was refreshing doing business with you. I'm impressed!
Randy
Watkinsville, GA