Jeep Spare Tire Carrier Specs:
Features:
Modular bumper with spare tire carrier replaces your factory Jeep bumper and carrier. Tire carrier swings out with tailgate with one motion. Holds tires up to 37" in diameter. Steel construction with matte black powder coat.
More Information >Jeep Spare Tire Carrier Specs:
Features:
Strengthen your factory tailgate on your Jeep to handle an oversized spare tire. Frame reinforces the tailgate to support extra weight. Works with factory and aftermarket spare tire carriers. Requires MORryde heavy-duty tailgate hinges to install.
More Information >Videos
for Jeep Spare Tire Carrier
Help Articles
for Jeep Spare Tire Carrier
Expert Answers
for Jeep Spare Tire Carrier
You are correct that the Jeep bracket should have been reinstalled when installing the Blue Ox Base Plate #BX1139. I have linked another video near the bottom of the page where you can see the brackets being reinstalled on a 2020 Jeep Wrangler…
view full answer...Yep, you're 100 percent on the money, Al. The 200 lb tongue weight capacity is only for what is put in the receiver and does NOT count the weight of the spare tire and the carrier itself for the Roadmaster Spare Tire…
view full answer...The Lippert Flow Max RV Toilet #LC67AF requires a minimum of 12" for the rough-in.
view full answer...Yes, the Roadmaster Spare Tire Carrier #RM-195125 can pivot to the left or right depending on what kind off clearance you have. We only show to the left in the video because there is a ladder on the right side, but if you check out the attached…
view full answer...Yes, the Roadmaster Spare Tire Carrier #RM-195125 will work on your Jayco Melbourne motorhome, and it is straight out so it won't lower where the factory receiver is. Keep in mind the receiver on the spare tire carrier…
view full answer...There are two possible options for you. The Dexstar Dual Wheel #AM20790 which is the 16" x 6" size you need with the 8 on 6-1/2" bolt pattern, uses flange nuts…
view full answer...It depends on what 5th wheel landing gear you have. For example; the Lippert Landing Gear part #LC333966 is rated for 6,000 lbs. It can be used with a trailer that weighs more than 6,000 lbs because it is only supporting part of that load - the…
view full answer...For the 6-point Level-Up System by Lippert, I made a call to the manufacturer to ensure you would receive correct information. Lippert said that when you bolt the footpads to the jacks, you need to torque them to 132 ft-lb. They said to make sure…
view full answer...We do have a few different options for you! If you are wanting an exact replacement then it looks like you currently have the Command LED Courtesy Light #328-002-04W. For a few different styles we have the Optronics #ILL85CB and #ILL86CB which are…
view full answer...In order to add a 7 way connector on you 2020 Jeep Wrangler JL you'll need to start by adding a 4 way trailer connector like the Tekonsha #118786, which gives you the connections needed to install a 7 way connector. Once…
view full answer...I went out to our warehouse and measured an outer bore diameter of 2-1/4 inches on the etrailer.com Trailer Idler Hub Assembly #AKIHUB-545-2-G-2K that you referenced. The reason we don't typically list this dimension on…
view full answer...The Lionshead Steel Dual Wheel, 4.75" Pilot - Silver, Item #LHHA420 is a 16" x 6" wheel with an 8 on 6-1/2 bolt pattern, so as long as your Class C motorhome…
view full answer...