Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
All of our trailer hitches that fit your 2006 Dodge Ram 2500 with a factory hitch, will sit below the factory hitch. Since you are removing your factory hitch, the Curt hitch I recommend is #14361 as it's 6-1/2 inches from the top of the receiver…
view full answer...As long as you are not exceeding the tongue weight rating of the trailer hitch receiver or dual hitch receiver adapter, you will not have any issues adding your 150lb accessory with the adapter as is, but I do not recommend modifying the adapter in…
view full answer...The PowertraxPRO MX Hard Tonneau Cover #RT90852, confirmed to fit your 2017 Toyota Tacoma with a 6 foot bed, is designed to install on top of the bed rails, unlike other covers which install inside of the bed rails; this helps to minimize the amount…
view full answer...For a set of crossbars and the feet that will attach them to your Retrax XR on your 2022 Ford F-350, you can use the Rhino-Rack Vortex Crossbar System for Retrax XR Series Tonneau Covers #RRVA180B-RRRLT600. According to Retrax, this will fit any of…
view full answer...I went to our warehouse and took a couple of measurements of the part #C15800. I have attached a photo of the trailer hitch and it has the dimensions noted. It measures 7 inches from the mounting lip to the top of the receiver opening and 9-1/2…
view full answer...Fulton ball mounts, like the #F47CR, are made overseas in China. If you were looking for something American made, you would need to go with something like the Convert-A-Ball #AMSC4. The Convert-A-Ball will have a higher 10,000 pound capacity, the…
view full answer...I like the CargoBuckle G3 Retractable Ratchet Straps, #IMF18800-77. These straps will attach on end to the trailer and the other end has steel hooks to attach to your trailer load. These straps have a max load capacity of 2,500 lbs and are in a set…
view full answer...Yes, you can use the Swagman E-Spec Bike Rack for 2 Electric Bikes #S94FR in both a 2" hitch and a 2.5" hitch. The Swagman E-Spec Bike Rack #S94FR is already designed to be used in a 2" hitch, so you are good to go there. In order to…
view full answer...The threaded portion of the hitch pin of the Yakima Backswing part #Y02483 is long enough to fit through a 2-1/2 inch hitch adapter.
view full answer...I made a picture showing 3 important measurements on the Draw-Tite adjustable ball mount #7390. The distance from hitch pin hole center to ball hole center is 11-3/4 inches. If the extra 2 inches is needed in a ball mount then of course it would be…
view full answer...I have a solution for you, but the part number AMCC2HD has been discontinued so your best option would be to get the #AMCC2 that you referenced and then use the Curt adapter part #C45405 to adapt it to fit a 2-1/2 inch hitch.
view full answer...I went out to our warehouse to take a look at the B&W Tow & Stow 3-Ball Mount #BWTS20049B referenced in your question. I measured a total length of right at 11 inches of the vertical adjustment shank on the ball mount. I have attached a short…
view full answer...Filter Your Search
Contact and Help