Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…
view full answer...Sorry to hear about the troubles you're having! To remove the Alpha Systems 4034 Roof Coating for RV Roofs #AL34CV from the side of your 1998 Tiago, you can use: - A type of chemical paint remover, - A Paint scraper tool, - A Pressure washer, Or…
view full answer...The prep you mentioned is more than adequate prior to applying the Alpha Systems 4034 Roof Coating for RV Roofs #AL34CV. According to the instructions you only need to apply the Primer #AL77CV if you're applying this to an EPDM membrane. In that…
view full answer...As long as you aren't exceeding the speed rating of the tires which would cause them to get to an excessive heat you are fine. Trailer tires are designed to be inflated to their max PSI rating when cold and then the pressure increase from heat…
view full answer...It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point Calibration The…
view full answer...I reached out to my contact at Lippert and they said that it sounds like you just aren't holding the 4 buttons for the reset long enough. It requires 5 seconds, but many people will count to 5 a little too fast and the system won't reset. He…
view full answer...Yes we do, for your AL-KO 10k axles the correct caliper for the left hand side of your trailer would be the #BP18-050. For the right hand side the part number is #BP18-060. For replacement pads you would want the Disc Brake Pads part #BP04-400.
view full answer...Determining the correct rise or drop for your Blue Ox SwayPro Weight Distribution System #BXW1000 is going to be the same method as determining rise or drop for a standard ball mount. You will just need to measure from the ground to the top of your…
view full answer...It looks like the lock is on a bed topper/camper shell or a custom utility bed. Without being able to see the entire lock cylinder removed from the assembly to see how it connects to the actuating arm for the lock, I couldn't say if any of the…
view full answer...In order to replace the Dexter 023-359-00 left hand and 023-360-00 right hand braking assemblies you will want to use the Dexter Nev-R-Adjust Electric Trailer Brake Kit part #23-464-465 which will replace both sides and it's a direct bolt-on…
view full answer...Yes, our Dexter leaf spring part #DX74XR is the same as the part number 072-079-00. This is a 7-leaf spring for an 8,000 lb trailer axle that is 24-7/8 inches.
view full answer...We don't carry Dexter leaf springs, but we do offer the 4,500, 26 inch long center eye to center eye equivalent as part #e27SR.
view full answer...Filter Your Search
Contact and Help