I attached a chart that has the automotive cross reference for the Kodiak disc brake pads part #K2250CP that you referenced under the yellow heading. Probably the easiest to look up would be 1982 to 1992 Chevy Cavalier.
On your 2010 Ford Explorer Sport Trac the factory plug for your brake controller will be located under the dash, on the left side of the steering wheel, just above your left leg. The wiring adapter you will need to connect the Draw-Tite Brake…
Hello Trent, Since your other lights are working on the trailer but your running lights are not, have you tried to turn your headlights on? I know in my 2024 Chevy Silverado I have to have the headlights on in order for the running lights on my…
The Timbren Axle-Less Trailer Suspension System - 4" Lift Spindle w/ Brake Flange - 5,200 lbs #TASR5200S03 is going to be your only option from Timbren to replace a 5,200 lb axle and have the 4" drop. Unfortunately there is no option for a…
I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…
Trailer axles like the Timbren Axle-Less Trailer Suspension System - 4" Lift Spindle - Regular Tires - 3,500 lbs #ASR3500S06 you were looking at are designed to work with trailer wheels that have 0 offset, so you will want to make sure the wheel…
Hey Jeanie, I think only 12" of lift is going to be a bit too short based off of your measurements. Instead, I recommend going with the Ark Xtreme Off-Road Swivel Trailer Jack w/ 2 Wheels #ARK39FR which has 24" of lift and collapses to…
For a hub that has a 5 on 5 inch bolt pattern to fit the spindles of the Timbren axle less kit part #ASR2KHDS03 you would want the Trailer Hub part #AKIHUB-550-35-K. This hub includes the bearings that the Timbren is designed to fit. This setup has a…
We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…
Trailer or automotive wheels can have a positive or negative offset. The offset refers to the distance between the mounting surface of the wheel that touches the hub and the center line of the wheel, as shown in the diagram I have edited for you. A…
To determine if the Dexter Trailer Hub and Drum Assembly for 3,500-lb E-Z Lube Axles #84656UC3-EZ is the correct fit for your trailer you'll just need to check the grease seal and bearings. This hub/drum kit uses inner bearing #L68149…
The Timbren Axle-Less Trailer Suspension System w Electric Brake Hubs #A35RD545E require a 5 on 4-1/2 bolt pattern and a minimum 14" wheel so the Dexstar Conventional Steel Wheel with Offset #AM20504 will be a compatible fit. This Wheel does…
Filters
