1998  x   >   Gen-Y Hitch  x   >   Lippert  x   >  

We have a 2017 Forest River Surveyor 293RTLS fifth wheel trailer. The pin box is a Lippert 1716 which is non cushioned unit. We are looking for something that we replace this that will control the chucking. Will the LC158777 help? Thanks. |...

when I remove the waste master hose for storage I need a cap to close end of hose. I also would like to have a better solution than little red stopper on exit end. I know I have the shut off but once as I was unpacking hose the shut off got...

Can I get a 2 5/16” ball on this type of adjustable hitch Thx | Actually the Gen-Y Bolt-On 2" Adjustable Receiver Plate # 325-GH-124 that you referenced does have a 2-5/16 inch hitch ball one of the sides. There's a 2 inch ball one one side...

requesting information compatible, first item # 325-GH-1301 Gen-Y Pintle Hook Mounting plate for 2-1/2 inch hitches 16-hole-21K . Question what WD weight distribution equipment is compatible with item # 325-GH-1301 for a smother ride and anti-sway...

Howdy. Id like to know if there would be any negative effects of installing of installing an over rated gen-y hitch on my toy hauler instead of the correct lower rated hitch. Based off of my trailers CGVW and tongue wieght my trailer requires...

I am needing to raise or lift my 5th wheel. What product do you have that I can use in conjunction with my top mount leaf spring axles? | When it comes to which lift kit you need for your 5th wheel trailer there are two options with both being...

Have 1998 fleetwood discovery.. Jacks will go down but do not retrack. I believe it the switch but mine is little different | You can try a reset of your powered landing gear setup to see if that clears the malfunction. The way to do this is...

I have a 1998 Glendale Golden Falcon 29RG 5th wheel, with a hydraulic 14 ft. Slide out. The original solenoid failed and burnt up most of the control wiring. I have 2 slideout contol switches inside and outside and I think they are wired correctly....

Hello we have an Aluma car hauler that doesnt exceed 5000 lbs, and a short wheelbase 1/2 ton pickup tow vehicle. The trailer imparts motions to our truck that doesnt feel comfortable, so we would like to purchase a device to absorb the trailer...

Will this fit a 2005 aspen f32 5th wheel | The Landing Gear Set w/ Handle # RVLG-8HDL can fit your 2005 Aspen, but you may have to cut off and weld on new mounting brackets to the frame if the weld stop spacing differs from your current setup....

Do these work as well for pulling trailers I have a 7 by 14 foot trailer I pull behind with my truck will this work with the trailers as well as it does the bike rack and cargo racks | An anti-rattle hitch pin will work for both hitch mounted...

Would like to know what all hardware comes with this awning? | The Solera Awning and Roller part # LCV000211457 only comes with the fabric and the roller. It does not come with any hardware beyond that. You will need the Solera Manual Pull...

does the roller come pre wound and ready to install ? | The awning roller and fabric kits like the # LCV000223161 are not pre-wound according to my contact at Solera. At the time of installation the awning roller should be wound fourteen rotations...

Does this awning come with all hardware to install on a camper that currently does not have an awning. My camper is a 1985 Jayco 28ft 5th wheel camper. I would like to install one if possible. If additional parts are required, could you give...