1998  x   >   !Glacier  x   >   Ranger  x   >  

I would like to add brakes to a ShoreLander PT2321A pontoon trailer. What parts would I need. The trailer currently has no brakes of any kind. Thanks for the help. Here are the trailer specs: Minimum Hull Length: 240 Inches Maximum...

when I remove the waste master hose for storage I need a cap to close end of hose. I also would like to have a better solution than little red stopper on exit end. I know I have the shut off but once as I was unpacking hose the shut off got...

1998 Ford Ranger XLT side step Will this work with the side step bed tail gate metal handle ? | Yes, we confirmed with Pop and Lock that the part # PAL2300 will fit your 1998 Ford Ranger with a metal handle so this would fit and work well....

Hello, I aim to tow a small camper and the manufacturer requires I wire my truck to the 7-prong six around one configuration lights plus electric brakes. Do you sell anything appropriate for my 1998 Ford Ranger? I only found the 4-prong...

Will these step fit a 1998 ranger regular cab 2 wheel drive truck | As long as you have access to the rocker panel then yes, the Pilot Aluminum Universal Side Step Bar # AS-400 will fit. This is a universal application and we haven't fit it...

98 ranger, w 7 pin electric brakes New kit just installed everything seems to work, Will charger sense when charged and stop? It seems a little hot so I opened lid and case been on 1/2 hr and still yellow? Voltage is 13.8 as being charged...

how much do i torque in 1998 trailer hitcth on a 1998 Ford Ranger | If you check out the installation instructions link I attached to the right you will see the recommended torque specs listed in the last step for the Curt hitch part # 13138. |

Are a 1998 Ford Ranger and 2006 Expedition King Ranch both with 4 pin trailer connectors pre-wired for a 7 pin connector? If yes, do you sell the 7 pin pigtail? | The 1998 Ford Ranger is not pre-wired for a 7-way. You can convert your 4-pole...

I need a replacement tarp for a 1998 Ford Ranger 6 Foot Bed, Stepside Extang BlackMax Tonneau Cover . | The Extang BlackMax that fits your 1998 Ford Ranger is # EX2600. The replacement tarp you need is # EX1600. To keep the tarp in great shape...

Can I flat tow my1998 Ford Ranger 2 wheel drive XLT wih a tow bar and part # DM9518060 ? | Yes, you can use the Demco Classic Base Plate Kit # DM9518060 with a tow bar to tow your 2WD 1998 Ford Ranger as long as the Ranger doesn't have tow hooks...

Im looking to purchase a Kats Heaters Lower Radiator Hose Heater but I see that the thermostat is set at 279 degrees. Since water boils at 212 degrees, wouldnt this over heat the coolant? Thanks | The Kat's Heaters Lower Radiator Hose Heater...

Hello, our AVAIL8422 plow just arrived. Hooking it to a 1998 Ford Ranger. Looks like I will also need a light kit as it will block my headlights, what is a good kit to use? | K2 recommends that their # K281488LB2 Halogen High/Low Beam Light...

Please help me, I need a brake controller and hopefully a wiring adapter for a 1998 Ford Ranger 4.0 liter engine, 4x4 Xlt ext cab truck, I am pulling a 17ft camper weighing 2750 dry weight. I am almost sure it has the towing package, It...

How can I convert this so it works properly. I have a 1998 ford ranger and it has a 4-way round connector. I can easily rewire a flat connector being most converters I see have that. Will everything work properly? The trailer is a 1984 Mallard...

What rack system would be best to fit over a camper shell that bolts to the truck bed. It would be used to hold Canoe, canopy, maybe a spare tire. For a 1998 Ford Ranger 6ft bed. With a leer fiberglass camper shell. | The roof rack that we...

I have a 1998 Ford Ranger XLT, 2 wheel drive with a style side bed and full size spare. I need to know if I will have to relocate my spare tire from under the rear of the bed in order to use this Class III trailer hitch. My spare is raised...

a grease seal just blew out on my new ez lube axle. to replace it, do I need to take all the bearings out? or, can i just take the hub off and put in a new seal from the back of the hub? Thanks | The bearings for your trailer hub don't need...

I got a 98 ford ranger looking for a replacement cover and I dont know what kind it is i just need a cover short bed 6 foot snaps on | We do have a replacement tarp for a snap-on tonneau cover for your 1998 Ford Ranger with a 6 foot bed, but...

1998 Ford Ranger Stepside with side rail covers and tailgate rail, the truck has no front bed cap, do i need a front bed cap to level out with side caps ? How much trimming is required on ths side rail caps plastic and with what tools do i...

What width range of adjustability does this have, how narrow can it go? | I contacted Pilot Automotive and found that the width range of the crossbar with the Bully Adjustable Ladder Rack for Full-Size and Compact Trucks # CG-902 is 42-1/2 to...

Does this cover fit a 1998 Ford Ranger Step-side, 2 wheel drive Splashbox? What is the #8740 alternate mentioned and what are the differences between the two? I want to make sure I get the right one. Will it hold up under snow and ice? Is the...

Hello, I was just wondering what rear mounting hitch would fit onto my 1998 Ford Ranger. I recently replaced the rear bumper with a Westin FEY Diamond Step bumper part #66000 if that makes any difference as to what models will fit. Thanks,...

I purchased a Adapter 4 Pole to 7 Pole and 4 Pole w/Test Lamps Item # C57674 by Curt. I had it installed and now the top red light is always on 12v indicator. This seems like a sure fire way to drain the battery. Can I install an on/off switch...

Need to know what models work for my 1998 stepside regular cab pickup. 2inch class 3. | For your 1998 Ford Ranger we have three hitches that have a 2 inch opening and a Class III designation. The Curt # 13138, the Curt # 13019, and my favorite...