Result:

What hardware is used to attach the 96inch predrilled rubber bumpers? | Hey Cassandra, The Redline Pre-Drilled Rubber Bumper # D4-96 uses a 5/8" nut and bolt in order to install. The hardware is not included so you can get that at any local...

I have a ‘56 airstream. My question is the trailer brake wiring. Do you recommend grounding each magnet wire at the axle area, or running a separate ground wire , along with the blue wire, up to the 7 point connector and tapping into the ground...

Since no 12 x 2 Warner electric brake parts are available I removed the Warner electric backing plate assembly from my 1960 Yellowstone travel trailer and it has a 6 bolt pattern for attaching the plate assembly. The lug pattern on the drum...

I have a C.R. 18823 grease seal on my 1956 airstream bubble trailer. It’s 3” OD. Do you have anything comparable? Thanks | Hey Larry, yes we do have a grease seal replacement for what you have with the part # 29031. This has the outer diameter...

I have trailers that I need door holders. They are 16’ trailers with a side man-door and barn door rear doors. The issue I have is that there is an awning that deploys on the curb side so when the man-door is opened it would hit into the awning...

Can you supply the dimensions of the item. | I walked out to our warehouse and measured the Redline Spare Tire Carrier # 413200. I took some pictures of part # 413200 and added some dimensions to the pictures for you. Click on the pictures...

I have dexter 10k lb axles on my trailer and am trying to find the proper nylon bushings for the leaf springs. They are 3/4” ID and 1” OD. Can you direct me where to find these? Thank you! | We have one bushing that matches the inner and outer...

Hello, I am fabrication a trailer that is 60 inches wide. Its a 5x10. I am planning on mounting 15 inch tires. The trailer frame is for a tear camper and will weight 1300lbs at most. can you recommend an axle that will fit the size of my...

I currently have a 2000Lb idler axle on my boat trailer and would like to add hydraulic brakes. My problem is it is not a standard axle. How much distance will I need from the back of the current seal for a brake flange. I will need to get...