Result: knobs

how do you remove old knob? | how do you remove old knob? | There really is no elegant way to do it. The knob is held in place by a pal nut, which must be removed. It might be possible to get a screwdriver in next to the nut...

Do you have replacement spin knobs? | Do you have replacement spin knobs? | We do indeed offer a replacement knob, the part # is BD500246. If you need the entire handle, it is offered as part # BD500180. Although the replacement...

How to install knob on trailer jack | How to install knob on trailer jack | That knob isn't make anymore but it would need to be positioned on the handle and then hammer on the pal nut that comes with it. |

This will accommodate a 1/2 inch shaft, and a washer and pal nut are included with this knob. I have included a photo showing this dimension. | what diameter shaft will this fit? thanks, | The inner diameter of the Replacement...

If so, your replacement knob is part # BD500248. I have confirmed this with Bulldog. | Sir: I have this jack from BullDog made in 88 with a 750lb lift cap. but can not find a model number on the sticker. I need to order...

What is the overall handle radius, not just to center of knob but to the outside of the knob? Im looking at this jack because I have a side wind but would like a top wind in order to be able to lower my tail gate with the trailer hooked up but need to make sure I will be able to turn the handle. |

Assuming your 8K Bulldog jack is a side wind with a 1/2 inch diameter shaft then yes, you could use replacement knob # BD500248 with your jack. It was designed as a replacement for 139, 159, 170 and 190 series jacks. | Will...

You could also remove the knob completely. Otherwise, I would go ahead and move the pipe mount a little further back. | Are there any alternatives to the handle length on this jack? Its just barely hitting the frame on every...

I also need a control knob for opening and closing the vent. And, a spare tire and rim, a Loadstar K550, ST205/75, D15. | I have a 2010 Royal Cargo trailer and I need a replacement vent top. Metal, if available, but plastic...

This kit provides the gear kit, crank assembly and black, teardrop style knob. | I have a Bull Dog side wind jack. I think 2000 lb. need gear set. both gears 12 tooth. .500 inside diameter. .550 gear heigth. 1.110 gear diameter. 4...

So I would use wheel locks and a coupler lock such as # FA86-0015-318 as an example (there are many types of coupler locks) similar to how a door might have a lock at the knob and a dead bolt lock. Now, if only the tow vehicle was that secure. |