Replacement Crank Knob for 8K Bulldog Side Wind Jack
Updated 12/27/2018 | Published 12/24/2018
Question:
Will this work on an 8000# bulldog?
asked by: Alan
0
Expert Reply:
Assuming your 8K Bulldog jack is a side wind with a 1/2 inch diameter shaft then yes, you could use replacement knob # BD500248 with your jack. It was designed as a replacement for 139, 159, 170 and 190 series jacks. Check the sticker on your jack to see if the first 3 numbers match the 3 digits listed above. You could also replace the whole handle using # BD500171.
expert reply by:
Michael H
0
Continue Researching
- Search Results: 72~80
- Search Results: jack handle
- Search Results: bearing buddy
- Search Results: door holder
- Search Results: 166074
- Search Results: bulb
- Search Results: equalizer
- Shop: Replacement L-Pins and Clips for Equal-i-zer Weight Distribution Systems - 6K to 14k - Qty 2
- Shop: SpeedStrap Off-Road Tie-Down Kit w/ Snap Hook & Axle Strap - 2" W x 10' L - Black - Qty 4
- Shop: 5-Leaf Slipper Spring w/ Radius End for 10,000-lb Trailer Axles - 30-1/2" Long
- Shop: Wet Equalizer Bolt with Castle Nut and Grease Zerk - 4-11/16" Long - 7/8" Diameter
- Shop: Replacement Black Handle for Ram Sidewind Jacks
- Shop: Erickson Ratchet Tie-Down Strap w/ Twisted Snap Hooks - 1-1/2" x 15' - 1,330 lbs
- Shop: Bearing Buddy Bearing Protectors - Model 2717A w/ Auto Check - Chrome Plated (Pair)
- Shop: Vehicle Tow Bar Brake System
- Q&A: U-Bolt Torque Recommendation for 1/2 inch Diameter On Trailer Suspension
- Q&A: What is the inner Diameter of the Cap Included with Replacement Black Handle # HDKB-BLK
- Q&A: Replacement Handle Recommendation for a Bulldog 190 Series Square Tube Jack
- Q&A: Jack Handle Replacement for Bulldog 8k Square Jack 190574
- Q&A: Replacement Handle for a 7,200 Pound Bulldog Square Jack