Result: knobs

how do you remove old knob? | how do you remove old knob? | There really is no elegant way to do it. The knob is held in place by a pal nut, which must be removed. It might be possible to get a screwdriver in next to the nut...

Do you have replacement spin knobs? | Do you have replacement spin knobs? | We do indeed offer a replacement knob, the part # is BD500246. If you need the entire handle, it is offered as part # BD500180. Although the replacement...

How to install knob on trailer jack | How to install knob on trailer jack | That knob isn't make anymore but it would need to be positioned on the handle and then hammer on the pal nut that comes with it. |

This will accommodate a 1/2 inch shaft, and a washer and pal nut are included with this knob. I have included a photo showing this dimension. | what diameter shaft will this fit? thanks, | The inner diameter of the Replacement...

If so, your replacement knob is part # BD500248. I have confirmed this with Bulldog. | Sir: I have this jack from BullDog made in 88 with a 750lb lift cap. but can not find a model number on the sticker. I need to order...

What is the overall handle radius, not just to center of knob but to the outside of the knob? Im looking at this jack because I have a side wind but would like a top wind in order to be able to lower my tail gate with the trailer hooked up but need to make sure I will be able to turn the handle. |

Assuming your 8K Bulldog jack is a side wind with a 1/2 inch diameter shaft then yes, you could use replacement knob # BD500248 with your jack. It was designed as a replacement for 139, 159, 170 and 190 series jacks. | Will...

You could also remove the knob completely. Otherwise, I would go ahead and move the pipe mount a little further back. | Are there any alternatives to the handle length on this jack? Its just barely hitting the frame on every...

It’s a 2016 OpenRange 3X fifth wheel. The knob is fine. | I’m looking for the window crank out assembly to open it. The threaded pin broke off inside. It’s a 2016 OpenRange 3X fifth wheel. The knob is fine. | Thanks for...

This kit provides the gear kit, crank assembly and black, teardrop style knob. | I have a Bull Dog side wind jack. I think 2000 lb. need gear set. both gears 12 tooth. .500 inside diameter. .550 gear heigth. 1.110 gear diameter. 4...

This also installs really easily with the included brake controller harness but it only puts a small knob on your dash as well. | 2008 Nissan Frontier.. I installed an Etrailer hitch and 4 wire wiring harness several years ago....

So I would use wheel locks and a coupler lock such as # FA86-0015-318 as an example (there are many types of coupler locks) similar to how a door might have a lock at the knob and a dead bolt lock. Now, if only the tow vehicle was that secure. |