Result: Step Support

If you prefer you can attach this lead, using a 40-amp breaker, such as # PK54540, directly to the battery positive terminal. Please refer to step F in the linked article. | How do I remove the fuse box cover in the engine compartment...

If the switches are there, does that mean tat the wiring is there to install electric steps. | It is very likely, but there is really no way to tell without looking behind the switch to ensure wiring connection and then down by the steps to...

| The ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000163 only draws 4.8 amps so you can get by with thinner gauge wire like 16 AWG which we sell by the foot with # 16-1-1. | Please...

I talked to the LaSalle, the manufacturer, and they said that you should be fine using the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat - 18-1/4" Long x 12" Wide Item # 277-000164 between metal and the rubber step tread on a school/commercial bus. |

| The ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000164 has a 4.8 amp rating. | The instructions for this water tank heater advise installing a fuse to protect against an electrical...

To wire the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000164, I recommend using the: -Universal-Design Rocker Switch # PK34310. | Do you have an inline switch available? I’m thinking...

| The first step I would take is to replace the 14 gauge wire for the electric brakes with either 10 or 12 gauge wire. | I installed 2 new magnets on one on each drum , new wire 14 gauge,replaced brake controller.Useing a...

| Yes, I can give you step-by-step instructions to install the Tekonsha P-3 Trailer Brake Controller, part # 90195, in your 2011 GMC Sierra 2500HD. | need to install p3 controller in a 2011 2500hd GMC truck...

We do have the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000164 available, which does have a built-in thermostat. | Item # 277-000161 Does this self regulate with a built in thermostat,...

I have also attached a helpful article that goes through this step by step that you can check out. | 2007 chev. pickup. I dont have a pigtail on the pickup. Under the frame I have four different plugs, all...

Even with a tow package, there may be some connections that need to be made under the hood. The article covers these steps. | I have a 7 blade tow connector that came with my 2000 Silverado. It has a factory...

To get the 12 volt circuit working on the 7-Way trailer connector on your 2003 GMC Sierra you will first need to go under the hood and remove the covers on the power distribution box. After removing the main cover and the cover under that you will see a post on the passenger's side front corner. |

| The ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat # 277-000164 each pull 4.8 amps so you'd need a switch that can handle at minimum 20 amps if you plan on powering them all off of the single switch. |

The use of small ring terminals make make this step a little easier. Keep in mind that the wiring colors that are labeled on the 7 way will not be a color for color match with those on the end loops. | I have a KarKaddy3 tow...

Even with a tow package, there may be some connections that need to be made under the hood. The article covers these steps. | My 2003 Silverado does not have a factory installed hitch but I did find the wiring...

Sometimes a vehicle will have the constant power option but doesn't have a fuse in place to send it through so the first step is to check the owners manual and make sure that fuse is in place and in good shape. | Is the tow...

I have attached a help article that has step by step directions for this installation and a video for you to reference. | will this unit wok for my 2010 chevy 2500hd silverado 4x4? I bought it for my chevy...

Yes, you can use two of the ThermaHeat RV Holding Tank or Step Heater Pad # 277-000163 connected to your DC fuse panel. | How would I wire the Therma Heat pad to the fuse panel in my RV? I have 2 of the pads...

I am including a link to the instructions on the Hopkins # HM47294 brake controller and a link to a FAQ page that will have a step-by-step instructions on how to wire a brake controller to your vehicle. | I...

You are probably overloading the circuit with both the sensor and the ThermaHeat RV Holding Tank or Step Heater Pad # 277-000163 on it. | Help! I got the ThermaHeat RV Holding Tank Heater Pad w/ Thermostat...

It is recommended to wire the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat - 25" Long x 7-1/4" Wide Item # 277-000163 through a switch so you can control the on and off. | If I should wire this...

You can easily check this by stepping on the brake and seeing if the third brake light of the vehicle comes on or not. | truck has factory 7 pole plug at hitch.Brake , turn , back up work at plug. when plug in brake connector...

If you're unsure of which locations to check, simply reference your vehicle's owners manual or the underside of the fuse box lid/cover. The next step would be to replace the connector altogether using the 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket part # HM40975 (bracket can be discarded). |

I have attached the complete installation instructions that you can check out, along with an image of the steps specific to the Audi Q7 that you can take a quick look at. | Specs on vehicle shows trailer hitch prewiring is...