Result: plug cover

Since you have an aluminum trailer I suggest using a tie-down that has a backing plate like #RR5K. This will help reinforce the tie-down since aluminum may not hold up. It would be even better if you can install the tie-downs to the frame of the…

I went out to the warehouse and pulled Curt Class V Trailer Hitch #C15300 and took some measurements for you. From the front bolt hole to the rivet (center to center) is 1-5/16 inches. From the rivet to the rear bolt hole is 7-7/8 inches and the…

Email me back with the pictures and I'll see if we can help.

If all of the lights on the circuit are the exact same like with the #CE36ZR you can wire them in series but if there's any different fixtures on the circuit the lights would need to be wired in parallel.

The Optronics 7-Way Trailer Harness Plug Protector #ACP7B has mounting hole spacing of 2-3/4" side to side and 1-1/4" up and down. This can be attached with screws, bolts or some people have even just zip tied it to their trailer tongue.

We have the Dexter Hub and Drum part #8-219-9UC3-A which is a 7k oil bath hub and drum. It would fit your current axle perfectly and allow you to convert it to oil bath.

Hi Jerry; an air compensated pintle hook like the Buyers Products 50 Ton Air Compensated Pintle Hook with Chamber and Plunger #337PH50AC is going to be the best option. However, none of our pintle hitch plates like the #3371809040 you looked at have…

While we don't have any custom fit hitch plates that fit your 2016 International 4300 we do have some universal mounts that would potentially work. You'd need to have a qualified welder install the kit. The hitch plates below all come with…

While there isn't a 3D model available, I was able to verify with the manufacturer and get a small diagram of the mounting hole dimensions of the Buyers Products 10 Ton Pintle Hook #337PH10. The mounting holes are exactly 0.531" in diameter,…

The Buyers Products 45 Ton Pintle Hook #337PH45 does not have the 4 inch square bolt pattern but rather uses a different pattern. Vertically the holes are 3 inches on center. Horizontally the top row is 5-1/4 inches on center and the bottom is 6-1/2…

Hey Jack, thanks for reaching out. What I recommend for you are the Ramp Springs #M376FR for left hand and #M366FR for right hand side. These are 2K rated springs designed for a 1-1/2" shaft. They are 10" long overall.

We do carry some nice heavy duty rubber plugs to protect the factory prep package on a Chevrolet Silverado. For this, you can use the Rubber Hole Cover part #RP30136 for the gooseneck hole and the Puck Plug Covers part #58199 for the pucks.