Result:

If your 2022 Sunset Park and RV Sunray 149 was set up for a Way Interglobal camera system, then it will be their Drive Wireless RV Backup Camera System # 324-000002. |

| Hey Kendrick, The Rear View Safety Backup Camera System # RVS-062710 would normally be wired to the running light circuit to be able to power it on and off as needed to prevent battery drain. |

| For a rearview camera system with both an auto-dimming and grid line feature you will want to use the Rear View Safety G-Series Backup Camera System part # RVS-776718-D which is also a confirmed fit for your 2007 Ford Explorer. |

I want to know if i can use this hitch for a 5000 lb rv | I want to know if i can use this hitch for a 5000 lb rv | Hey, Javier. The Equal-i-zer #EQ37120ET you were originally looking at is rated for 800–1,200 lbs of tongue...

My RV is 2019 Winnebago Minnie 2500FL. It measures 31foot 2inch from front to back, including rear ladder and spare tire, excluding hitch. | My RV is 2019 Winnebago Minnie 2500FL. It measures 31foot 2inch...

I have listed them below. 4-Point Set - Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad item # LC358590 6-Point Set - Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Bluetooth Control item # LC675817 These kits come with everything you need to get a Ground Control 3.0 system installed. |

As long as the tongue weight of the trailer plus the weight of anything stored in the cargo area of your Explorer behind the rear axle does not exceed the 750 lb tongue weight capacity of the system, the # PS49582 would be a good choice for you. |

Ive seen videos from CanAM RV in Ontario, Canada that these vehicle types can tow a 30ft Airstream if properly outfitted with weight distribution systems. | Hello, my Edge can tow max 3500lbs w/350lbs. Ive...

This system only needs to be installed once and can be mounted under a seat or in the rear cargo area out of the way. | I just purchased a 2013 Ford Explorer and want to know what is required to flat tow it...

A mounting bracket like # 18144 is recommended to keep the connector secure if you are mounting it to the hitch or rear bumper. If you have a trailer that requires a 7-way socket then you can install the Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires # ETBC7 after you have the 4-pole wiring harness # 118551 installed. |

This comes with a round 6-way connector that you will install on the front of your towed vehicle and enough coiled wire to go from there to the RV. To convert the 4-way connector at the rear of your Motorhome to a 7-way will require the # ETBC7. |

This comes with a round 6-way connector that you will install on the front of your towed vehicle and enough coiled wire to go from there to the RV. Dinghy wiring the 2015 Ford Edge SEL model is quite a bit different than normal diode wiring because Ford combined the stop, turn and taillight signal on the same wire that goes to the rear facing LEDs in the taillight. |

This wiring harness connects to existing wiring in the rear of your Explorer and does not require cutting, splicing, or tapping. | I have a 2021 Ford Explorer without a tow package. I am looking for a hitch that can haul a...