Result: knobs

Due to how convenient it is, I definitely recommend the RidgeBack, which is the following part number: - Yakima RidgeBack 4-Bike Rack # Y02458 There are a lot of similarities between the two racks, but the one thing that makes the RidgeBack # Y02458 the better option is how much easier it is to install in your hitch. The RidgeBack uses a knob, called a "SpeedKnob" to install in your hitch; all you have to do is insert the rack in your hitch, push a pin in, and twist a knob. |

This carrier uses a bottom plate under the crossbars that attach to the rest of the carrier sitting on top of the crossbars and everything is held there with bolts and knobs. It will install the same way on your Rogue as in the video I have linked for you. |

The EasyFold XT has a nifty ramp so you can easily load your bike, allows for simple access to your vehicle's rear cargo area via a foot lever that you can press to tilt the rack down, and tightens in your hitch with the twist of a knob. IT also gives you security with integrated locks in the clamps that secure your bikes to the rack and a lock in the knob that secures the rack to your hitch. |

That bolt is what the anti-rattle device pivots on as you tighten it. As long as the knob can still turn by hand it's not too tight. If you went back to the same position it was in prior you are totally fine. | I recently purchased...

That's unusual, in order to stow the Thule EasyFold XT Bike Rack for 2 Electric Bikes # TH903202 you'd have to: -Loosen the lockable knob, -Pull the pin out, & -Push the small lever on the bottom of the rack and rotate the rack toward your Rogue to give you a bit of leverage and then you can use the grab handles on top to pull it out of the car. |

This rack will install on your Insight as follows: set the Fit-Dial knob to number 8; place top clips in the gap at the front edge of the top of the trunk; place lower clips in the bottom edge of trunk; the side straps can be positioned on the side edges of the trunk. |

Pro Tip: Spay some lubricant like WD-40 or PB Blaster on the rubber isolators to make it easier to remove the hanger knobs. | I purchased the replacement CURT trailer hitch hardware from eTrailer for this hitch and installed...

It installs in your hitch without any type of tools by simply turning a knob to tighten the rack in the hitch. The Sherpa tilts down (even if your bikes are loaded) with the simple press of a foot lever, which allows you to access your rear cargo. |