How To Wire A 12V DC Tankless Water Heater In An RV That Previously Had A 120V Water Heater
I currently have a gas electric hot water heater. The electric is 120 volt. The tankless units are gas and 12V DC. Will I need to find or run a 12V DC source from somewhere or should there already be a 12V DC source at the present unit.? | For...
What Parts Do I Need To Install My New Tankless Water Heater With The Pressure Relief Valve In Back
My present hot water heater has the pressure relief valve venting out of the front of the unit. Thoughts on how to work the logistic of routing the vent plumbing from the back when replacing with a tankless unit? | You will use Camco RV Water...
Installing Shorter Solera Slide-Topper Due to Clearance on 156" Box Width
Can Shorter Slide Topper be Installed for Clearance? This was a question asked by another customer and I have a similar issue and question. Below is what was previously asked but the size of awnings are different. Here is my flange to flange...
What Replacement Snap Pads Will Work With My Lippert Ground Control 3.0 9 Inch Round Feet
We have the Lippert Ground Control 3.0 jacks on our 2021 Keystone Laredo 5th wheel. The jack feet on the back are 9 in. round but the front are 8 1/2 to 8 3/4 in. round. Will the 9 in. Snap Pad fit both front and back with the difference in...
Availability of Flush Mount Fireplace for 33" x 19-3/4" Opening
Can you help me find a rv fireplace that would fit into a 33 x 19 3/4 opening. Flush mount. thank you! | The closest fireplace we have to what you are looking for is the 34" Furrion RV Electric Fireplace with Logs # FF34SW15ABL which needs...
Selecting The 3 Step or 4 Option of the TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear
When measuring the factory steps on my 2013 Keystone Laredo 329 RE, I definitely need the 27inch wide assembly. My question is whether I need 3 steps or 4. The height of the mounting bracket is 33inch when level on a concrete pad. I believe...
Recommended Tankless Water Heater For 2018 Keystone Laredo Fifth Wheel RV
What tankless water heater would be recommend for A 2018 Keystone Laredo 5th wheel? Currently has factory installed gas/electric type model. | There are a few options when it comes to finding a tankless water heater for your 2018 Keystone Laredo...
Replacement Bearings, Races and Grease Seal For Dexter 4,400LB Axle Under 2021 Keystone Laredo
I have a 2021 Laredo 255srl fifth wheel with Dexter axle no: 248744 of 4400 lbs and I would like to know the part numbers of the internal and external bearings, race complete set beauring, race, seal Thank you Jai une fifth wheel Laredo 255srl...
Replacement Front Jack for Lippert Ground Control 3.0
Hello, I am looking at your part 179013 and 179014. I have 3.0 Grounding and they do not look the same and could you tell me if you carry a replacement part for my leg. My legs have motors mounted directly to the leg. Keystone Larado 2018...
Will Grease Seal GS2125DL Replace Seal that Measures .375 inch
My current seal has a thickness of .375inch and the replacement part GS-2125DL has .31. Does that matter? Also, the grease caps I ordered 2.44inch OD RG04-080 using the vehicle feature mode on etrailer does not fit my 6K lb Dexter axle. Those...
Could Wheel Masters Level Master 2 Trailer Bubble Level # WM67200 Install with Adhesive
Is there a way to attach this with adhesive. | I am sure you could use adhesive to attach the Wheel Masters Level Master 2 Trailer Bubble Level # WM67200 to your fifth wheel if you wanted to but we don't have an option for that. You could use...
Replacement For A Recessed Puck Light With A 03-HPG 46 LED Light Bulb
I have a 2016 Keystone Laredo and the pick lights above my couch and recliner have faded out. I measured the lens and it’s closer to 5” but the base opening is 3”. Mine also have only 6 led lights …can you suggest a proper replacement? | We...
Troubleshooting an ACMHD Heat Strip in a AC135SP A/C Unit
My RV has an Advent AC135 AC135SP non-ducted A/C unit. I purchased a ACMHD heating element and installed it in my unit. Installation was very simple. A few screws to mount it inside the unit and plug it in to the connecter for the heating...
Reinforcing A Bumper On A 2015 Keystone Laredo 336TG
Please note my 2015 Keystone Laredo 5th Wheel model 335TGs rear bumper is only rated for 150 lbs. How do i mount this Cargo Carrier with a capacity of 500 lbs to bumper to ensure the bumper does not break away / fall off while in transport?...
Replacement Wiring Harness for Lippert Ground Control 3.0 System
Need a couple of the 3 pin connectors that goes in to the board where all the jacks plug in | The connector you sent in a picture of appears to be the wiring harness from a Ground Control 3.0 system like part # LC307490. We don't have a way...
Recommended Self Adjusting Brakes for 2014 Keystone Laredo 5W Travel Trailer
Need to replace the dexter brakes I have on my fifth wheel TT. Below is the part # the right hand set. I’d like self adjusting thanks Dexter backing plate part #023-463-00 | Based on your Dexter brake assembly information, it looks like you've...
Where Does Gooseneck Hitch Ball Normally Sit in Bed of Truck
What distance from the front bed rail does the gooseneck ball in trailer need to be. | Ideally the gooseneck hitch ball gets centered right above the rear truck axle or sometimes up to a couple inches forward from that point. This puts the pin...
Troubleshooting 2010 Keystone Laredo 245RL Landing Gear Blowing Fuses
Hello, I have a 2010 keystone Laredo 245RL 5th wheel and just recently while trying to leave the camp ground the landing gear motor would throw 30 amp fuses while trying to raise the camper. The motor would run fine then slow down and blow...
Troubleshooting Blwon/Melted Fuse for Landing Gear on a 2007 Keystone Montana 5th Wheel
I just replaced the gear reducer and installed new switch to raise and lower landing gear. When running the motor the wires got hot and burned out the 30 amp inline fuse on my 2007 Montana 5th wheel. | The best place to start looking when you...
How To Find the Correct Replacement Landing Gear Legs for a 2013 Keystone Laredo
I have a keystone larado 335tg 2013. We had a really bad storm last night resulting in my landing gear being bent really bad. I can’t seam to find any where what model to get to replace my gear. If I can I would like to be able to get a little...
Upgrading the Coleman MACH Airxcel Rooftop AC on a 2013 Keystone Laredo 5TH Wheel Camper
I have a Keystone 2013 Laredo 5th wheel with an Airxcel 48000 series ac unit and a coleman mach thermostat. I want to upgrade to a bigger unit. Can you recommend what will be needed to do this. | Without knowing the exact model number on your...
Are The Econo Porch Trailer Step with Handrail and Landing # EHS-103-R Shipped Assembled?
I think these steps the Econo Porch Trailer Step with Handrail # EHS-103-would work for my 5th wheel as the height from ground to entry is about 30 inches. Does this come assembled? I have seen on other websites that these Econo porch with...
Is The Correct Track Kit Compatible With Lippert Road Armor Equalizer On a 2021 Keystone Laredo
The RR23QX kit does this on a 2021 Keystone Laredo 255srl fifth wheel with Road Armor suspension with wet bolt in order to align the axles. Thank you Le kit RR23QX fait il sur une fifth wheel Keystone Laredo 255srl 2021 avec une suspension...
Can JTs Strong Arm Stabilizer Bracket Mount on Inside if I-Beam
I have an IBeam frame. My gas line runs somewhat center towards outside of the frame. Can I mount the brackets on the inside lip of the I frame? | Hi Darin, Yes you can mount the brackets to the inside of your I-beam when installing the JT's...
Filter Your Search
Contact and Help