!Oldsmobile  x   >   1994  x   >  

The light I have is a kll s-9 s100R/100A it has 4 mounting holes do you have ones like that or what Should I use its on a 2000 Wanderer | I am happy to help you replace your taillight on the 2000 Wanderer. However, I was not able to find any...

I bought a wiring harness at u-haul for a 1994 ranger 2.3 where does the wires go it did not com with 2 plugs leaving me with the wires to put to hook to where do they go red brake yellow left signal green right signal brown tail lights white...

Hi, I am looking for a front mount hitch for a 1994 Ford Club Wagon. Can you recommend which hitch would be compatible? Thank you! | The Club Wagon is simply a different name for the Econoline of the Ford van, and we do have a front mount trailer...

Everything is hooked up correctly and I get voltage at the brakes but when I check the brake wire I have approximately 6-7 volts then when applied I get full voltage , but I only get a red dot on the controller. | On the Draw-Tite Activator...

Like som specs and reviews on the Putnam hawkeye15091 and some info for under bed brackets | I have another option for you that has great reviews and is similar to the hitch you mentioned, but we do not currently carry Putnam products. I recommend...

does hitch receiver come with fasteners needed to for mounting. | Yes, the Curt hitch part # C14081 that you referenced does come with the install hardware needed to install on your truck. |

I tow A 18foot flat deck car hauler with a 1994 Land Cruiser/ rock crawler on it. The Cruiser has 37inch tires on it. Would this chock and a over the tire strap be suitable for this set up. Or maybe just the Chock as A stop and use my current...

Need a kitchen faucet for my 1995 Lance truck camper What would you recommend ? | We have a large selection of RV kitchen faucets available and the right one for your 1995 Lance truck camper is going to depend both on your existing setup along...

I have a trailer hitch on my Blazer and I looked for the place where your connector hooks in. I do not know if it has a tow package so if it does not have that product, can your part # 41125 still be used. If so please tell me how to find...

I have a 1994 Chevy P30. I need a mounting bracket to adapt to my 3” x 10” bumper to be able to install the GennyGo 24x24. Can you advise the parts I need to order? | In order to haul a generator on the front of your vehicle, I suggest using...

Good Afternoon, Ive a 1994 Ford Escort, I am in need of a front tow bar set-up to tow this vehicle as tow-behind. Please advise on a few options. Thanks | To flat tow a vehicle you will need at least 5 items: base plates, tow bar, safety cables,...

I have a 1994 toyota pickup not a t100 just the basic old 22re. it has tail light/brake, turn a and backup light. i put on a round 4 pin socket, but the boat trailer an old ford has only two lights. I figure I need a converter but it has 5 wires....

I have a 1994 GMC Safari Van with the towing package. According to my Brake controller instructionsTekonsha there should be a 10 pin connector that the red wire is connected to. I dont have that connector. I connected Tekonsha tech dept and...

I am interested in your disc brake conversion #k2hr958q011....with the hydrastar actuator..what can I expect. will I have better stopping power? Installation? | If you would be going from drum brakes to the disc brake kit part # K2R1058D11...

Looking for a class 3 hitch for my 1994 k1500 that will allow a full size spare tire and wheel to fit under the bed. The hitch currently in the truck will not allow the spare tire to be winched up properly. Tire size is 265/75R16. | According...

Hello, I have a 1994 Saturn sl2 with Q towers and Q13 clips. Will the Yakima C pads work in place of the A pads? | Yes they will; what you can use is the Replacement "C" Pad for Yakima Q Tower # Y8810083. |

Will this fit 94 bronco xlt ? Do the mounting holes line up to factory brackets ? ...thank you | The correct Westin Surestep Rear bumper for your 1994 Ford Bronco is part # 21002-95600. This includes the bumper and the vehicle specific bracket...

will a Draw-Tite # 37130 hitch fit my 94 F150 xlt 4x4 with step bumper? | Yes the Draw-Tite Trailer Hitch # 37130 is designed to fit a 1994 Ford F-150 with a standard or step bumper so this will work for you. To install a 4 pin trailer connector,...

We offer a hitch that would fit your 1994 Pontiac Bonneville SSE. The Draw-Tite Class II Receiver Hitch, part # 36216 is custom designed for your vehicle. With this hitch, the manufacturer recommends the Class II draw bar, part # 36061. You...

I have a 1994 Mazda B-4000 pick up.Just want to make sure this is the right one for my truck. I recently bought a magnetic tow light kit for my truck and I hooked it up and I had tail,brake lights and a right turn signal but no left one.I probed...

I have 2 12 volt start batteries and 4 Trojan 6volt batteries for coach power. Would the Gen 4 be the unit to use for this application? I would plug the ac cord into the 10K gen and it would supply current to the charger. How would I connect...

I have a 1994 Nissan Quest mini van. I wanted to use a 3 bike rack. If I want to buy Hitch mounted bike rack do I also have to buy the trailer hitch separately. Will the Thule Metro Trunk Mounted 3 Bike Carrier TH967 work instead? What are...

What is the best front hitch for a 94 Chevy K2500 4x4 to use a snow plow? Is it durable enough for snow plowing and what snow plow would you recommend? | For your 1994 Chevy K2500 4x4 the front-mount hitch I recommend is the no-drill Curt model...

I need a replacement shroud for my Coleman TSR model 7333B8876 ? | We do offer a replacement shroud for your Coleman Mach 3 model 7333B8876 air conditioner; with the correct replacement being from MaxxAir: - MaxxAir Replacement RV Air Conditioner...