Class V Trailer Hitch for 1973 Ford F-350 with 34 Inch Frame
I am looking for a trailer hitch that is the standard and sits right below the step bumper. The truck is a 1973 F350 and has the narrow frame which is outside to outside or 34 inches. I dont really see measurements for all of the hitches that...
Will the Westin Fey Diamondstep Bumper # 73000 Fit My 1977 Ford F-250?
will this fit my 1977 ford f250 | I have a solution for you. Unfortunately, the Westin Fey Diamondstep # 73000 will not fit your 1977 Ford F-250. However, for the correct bumper and mounting hardware, you need the Westin Fey Diamondstep Rear...
Gooseneck Hitch Recommendation for 1973 Ford F-100
I need a turnover ball gooseneck hitch. For my 1973 ford f100 2wd | I wish we had a B and W Turnover gooseneck hitch fit for your 1973 Ford F-100 but B and W does not have any fits that go back that far. We'd only really be able to help with...
Replacement Red Oval Clearance Light for Itasca Sunova Motorhome
Sae ap2-16 is the number on the lens do you have any | It sounds like you are just trying to replace an old oval clearance and if that's the case we have some great options. That said, the numbers on the lens of the light (SAE ###) are not part...
Where to Find the Taillight Connectors to Install a T-One 4-Pole on a 1983 Ford F-250
I have a 1983 Ford F250 in which I am going to hopefully install a vehicle this wiring so that I can tow my Trailer. The Trailer has a Flat 4 pole connector, I see that this item Plugs into a Plug? I been under my vehicle and I have never...
Towing Mirror Fit for 1966 Ford F100
Will your review view side extension fit a 1966 Ford F100 pickup with original side mirrors that are round and quite small | The CIPA # 11902 you'd looked at would fit the mirror shown in the provided photo, which is found on 1999-2008 Ford...
Installation of Blue Ox Heavy-Duty Universal Bolt-On Adapter Tabs
I would like to purchase the 20,000lb bolt on blue ox tabsBX88266. I am using a blue ox Aventa II towbar. What is the minimum and maximum distances between the mounting tabs for this towbar setup? | The Blue Ox Heavy-Duty Universal Bolt-On...
What do Trailer Acronyms GTW and TW Mean
what is the difference between GTW and TW | In the trailer world GTW stands for Gross Trailer Weight, and TW means tongue weight. Gross trailer weight is the entire weight of the trailer and tongue weight is the amount of vertical load that...
Adapter for 4-Flat on Truck and 7-Way on Trailer
will this connector work for a 7 way on the trailer to a 4 way on the truck | We do have a solution for you, though the Reese Trailer Connector Adapter # 78118 will not work for you. Instead I recommend the Hopkins Endurance Quick-Install Trailer...
Recommended Trailer Hitch Compatible with 1968 Ford Truck
Will the Draw-Tite - FORD VANB.Y - 75315 model hitch fit on a 1968 Ford truck..? | The Draw-Tite 75315 hitch has been discontinued, but is only a fit for Ford Full Size Vans. It will not fit a Ford Truck. For your 1968 Ford Truck, I recommend...
Goose Neck Hitch Options for 1975 Ford F250 Crew Cab with 34-Inch Frame
I was wondering if there was any kind of a hidden gooseneck hitch or gooseneck hitch in general for a 1975 f250 crew cab with the 34 inch frame? | There are no direct-fit goose neck hitch options for your 1975 Ford F-250 crew cab. However you...
Custom Snow Plow Mount for 1976 Ford F-250
Do you have a custom plow mount that will fit a 1976 Ford F-250 4x4? I have looked elsewhere and and have had no luck. | You're in luck because there are custom mounting brackets for a snow plow that fit your 1976 Ford F-250 (so long as it is...
How to Add Base Rails for Reese 16K Sliding 5th Wheel Hitch on a 1963 Ford Flatbed Truck
I have a 1963 Ford flatbed truck that Im needing to install a 16k slider Reece fifth wheel hitch on to haul a 33 ft trailer. Is this possible? If so what do I need to get. | We have some universal base rail options out there but nothing that's...
How to Measure for Trailer Hitch Clearance on a 1963 Ford F-100 With a Rear Barden Bumper
I am looking for a Class III receiver to fit the subject vehicle I want to keep the bumper. Will the 41001 hitch clear the barden bumper? What measurements would I need to ensure that there is no interferance. | When mounted, the top of the...
Bolt Hole Spacing Drivers Side Frame Rail to Passenger Side Frame Rail B&W Heavy Duty Receiver
left to right hole spacing with hitch configured for 34inch frame | The Hole spacing for the B&W Heavy-Duty Trailer Hitch Receiver # BWHDRH25198 are as follows(all measurements are for center of hole to center of hole). 34" Width Frame -Front...
Replacement Vent Lids For Motorhome Bathroom And Kitchen
We need replacement vent lids for our 2015 Itasca Sunova Winnebago motorhome. The bathroom vent is a 13x13 and the kitchen is a 14x14 Fan-tastic. We would like smoked lids. There is a model number inside the 14x14 vent of 810177. If you could...
Why is There Only One Ground Wire on the Adapter 4-Pole to 7-Pole and 4-Pole Part # 37185
On part #37185 why is there no ground wire coming off of the Four flat connector that plugs into the existing 4 way? Is the single white wire the ground for both the 4 flat and 7 round? If so can i use the part #40105 T connector in my wiring...
Replacement Rear Bumper Options For A 1976 Ford F-250
Looking for rear bumper mounting kit for a 1976 Ford f250 4x4 has a narrow frame 34 | Yes, we have the following style options available for your 1976 Ford F-250 with brackets compatible with your 34" frame: Westin Fey Surestep Deluxe XLT Rear...
Replacement Puck Light for 2015 Winnebago Itasca Sunova
I have a 2015 Winnebago Itasca Sunova and need to replace some of the puck lights. I need to make sure that the replacements are the same footprint as the existing. The frosted glass lens cover of the existing units is 3 1/8inch diameter, and...
Hitch that Fits 1977 Ford F-250 with Narrower Frame
Ive got a 1977 Ford F-250 4x4 and my frame is narrow, I do not want to drill any holes as well | Sounds like you have a cab and chassis model Ford F-250 which has frame dimensions of 34 inches measured from outside to outside which we have hitches...
What is Needed to Add Detail K2 Rampage II Snowplow to 1983 Ford F-250?
Detail K2 Rampage II Snowplow - 82inch Wide x 19inch Tall Item # K2RAMP8219 I need a snow plow for a Lifted 1983 Ford F-250. Does your snow plow come complete with ALL items needed to assemble and plow snow? It has a 6 inch lift. | To install...
Installation Instructions for Prodigy P3 Brake Controller in 1973 Ford F-250
Just bought a p3 brake controller from you guys and am installing on a 73 f250. I wont have a lot of time to install so was hoping I could get a little advice and direction so when I get it I can hit the ground running...any help, even some...
Trailer Hitch Receiver Fit For 1965 Ford F-250 With Custom Bumper
I have a 65 Ford F250 2WD truck with a unique rear bumper customized by the original owners. I need to see if you have a hitch that would work with this. | Outstanding photos thank you so much for sending them, and based on that we do have...
Towing Package and B&W Class V Trailer Hitch Fit for a 1977 Ford F-350
Hello. I was wondering if the BWHDRH25198 will install on a 1977 F350. Thank you. | Yes, the B&W Class V Trailer Hitch, # BWHDRH25198, will install on a 1977 Ford F-350, but it was designed for models with a 10 inch deep drop step bumper. The...
Filter Your Search
Contact and Help