When Using the Redarc Tow-Pro Elite In User Controlled Mode Does the Power Ramp Up or Apply Instant
This looks like the perfect controller for my needs: running a trailer with 12V electric brakes from my 24V antique military truck. I also like the small knob on the dash with the main controller mounted remotely. I do have one question: when...
Recommended Air Brake to Electric Brake Controller for 1969 International Loadstar 1890 Truck
which controller would give better performance I have noticed that instead of using a brake controller like this one, 1300-80, it is recommended to use the , # 90885, brake controller. Is the electric brake controller as consistent with braking...
Can Bulb be Replaced on Peterson Red Flush Mounted Sealed Turn Signal Light 435800
is bulb replacable on this light? what is replacement bulb # | Peterson brake/turn signal light # 435800 is sealed and cannot be opened up to change out the bulb. I pulled one from the warehouse to verify this and cannot get the lens off (without...
What is Correct Placement Of Goose Neck Hitch Ball in Full Size Pickup
where in the bed does the ball have to be front to rear ? over the rear axle,slightly in front the rear axle or can it be 8inch to 10inch behind rear axle??? | A goose neck hitch ball, or the center of a 5th wheel hitch head for that matter,...
5th Wheel Installation Kit for a 1976 Dodge Ram Power Wagon with 6 Foot Bed
is there a install rail kit for my 76 dodge power wagon or will a 2006 dodge ram kit fit my truck | Yes, we have an installation kit for your 1976 Dodge Full Size Pickup with 6 Foot Bed. You will need to use the Reese Universal Base Rails and...
Adjustable Hitch for 1972 Winnebago Brave with Modified Frame
Im looking for a class 5 hitch with 2inch receiver for my Winnebago. There is no ion and the specs are hard to find. The Frame rails C-channel outside to outside at the rear are 34 inches apart, and are 1.75 wide at the rear section. Welded...
How to Determine if Wheel Will Fit on Trailer
Hello, before I order this wheel want to be sure it will fit | I'm happy to help you figure out if the Dexstar Conventional Steel Wheel w/ +0.5" Offset - 16" x 6" Rim - 8 on 6-1/2 - Black # AM20766 will fit on your trailer. In order to determine...
How Much Power/Amps Does the Tekonsha Prodigy P3 Draw
Can you tell me what a typical initial surge current Amps or power Watts is for a Tekonsha P3 brake controller when brakes are initially applied? Im mostly running this with a single axle trailer, but will occasionally use it with double axle...
Nerf Bars That Fit 1978 Dodge W150 Truck
Looking for mounting brackets for my Westin 3inch Nerf Bar/Step that Im looking to mount to my 1978 Dodge W150. | There is an option to add nerf bars to your 1978 Dodge W150 truck, though I checked with Westin and they do not have a fit, and...
Will a Sierra Brand 4-Way Flat Trailer Connector Fit Tow Ready Mounting Bracket
I have a Sierra brand tow vehicle 48inch pigtail with connector. Do you know if it will fit this bracket? | Mounting bracket # 18144 fits most 4-Way flat trailer connectors. We don't have Sierra brand connectors so I can't test it. We do know...
Can Peterson Round Flush Mount Trailer Light be Installed in 1/8 Inch Thick Diamond Plate
i am mounting tail lights in 1/8 diamondplate. is this the product i want? i just want to cut the holes and mount with a rubber grommet. i do not want to have to attach light in back or anywhere else. your video explains nothing about mounting also...
Curt # C15845 Dimensions - Clearance and Mounting Bolt Spacing
We have an aftermarket bumper on our truck and Im trying to see if this hitch will work with it. What is the clearance from the top of the receiver tube to where it mounts on the frame? Also, what is the horizontal clearance of the mounting...
Recommended Tow Bar and Base Plates for Flat-Towing 1952 Dodge Panel Truck
I want to tow a 1952 Dodge Panel Truck. Can you help the right tow bar and mounts? Thanks. | We do not offer any custom-fit base plates for your 1952 Dodge panel truck but Blue Ox makes a set of heavy-duty bolt on base plates designed to mount...
Brake Controller Recommendation for a 1976 Dodge RM300
My question is, what type of brake controller do I need for a 1976 DODGE RM300 RV CHASIS? Since the vehicle isnt setup like a newer plug an play vehicle, is there a certain type of controller I need. Thanks for your time! | For a brake controller...
Time-Delayed Brake Controller Recommendation to Match Tekonsha Wiring on Truck
Does Tekonsha make a time delay brake controller that uses the same wiring harness plug as the P3? I have installed a P3 and can’t get it to work right so want to go back to a more basic and simple to use controller and hoping Tekonsha makes...
Recommended Trailer Hitch and Wiring for 1965 International Travelall
Hi, Im looking to purchase a Curt Hitch 14082. what would the appropriate 4 pin flat connecter harness and brackets be? I have a vintage 1965 Travelall that this is going on. There are numerous choices for the wire harness. I like the the idea...
How to Measure to See if Curt Hitch part # C15300 will Fit Truck
My 1968 dodge D100 has a frame width outside of chassis both sides of about38 or 38-1/4. I was told I needed the c15300 here but the width youve stated in the QandA is 37-1/4. Am I missing something? Thanks | What you will want to do is...
Is Drilling Required to Install B&W Trailer Hitch Receiver # BWHDRH25122 on 1976 Dodge Truck
It states that no drilling is required, is that really true? When I searched this part number many other makes come up attached to it. So just want to know if it is a true no drilling required or not. Thanks | To install the B&W Heavy-Duty...
5th Wheel Install Kit Rail Placement on a 1975 Dodge D200 Long Bed
I have a 1975 Dodge D200 2 wheel drive with 8 foot bed. what is the measurement from end of bed to rear base rail. I am installing a Reese 14k 5th wheel hitch with universal mounting kit. | Using Reese universal installation kit # RP30035 on...
Can the Trailer Clearance Light part # MC53RB be Flush Mounted
looking for a way to flush-mount this light. am using with 4 inch round grommet mounted 435800 tail lights would like it to have the same profile.. can this be done or do you have another 2inch light to suggest. i dont want it to stick out...
Dimensions of Westin Fey Diamondstep Rear Bumper for Vintage Truck
I put my info in and it says your bumper fits but can not find any actual measurements it for a 1960 dodge d100 | The Westin Fey Diamondstep Rear Bumper - Silver Powder Coated Steel # 20002 has a length of 74-1/2 inches. I reached out to my...
Trailer Hitch Availability for 1967 International Travelall 1200B 4x4 3/4-Ton Panel Truck
Have a 1967 International Travelall 1200 B which is a 4x4 3/4 ton panel truck. Would like to have a hitch similar to the Curt p/n 15320 that I installed on my Chevy because I have a spare tire mounted underneath the rear similar to the Chevy...
What Tire Chains are Good on Ice and Will Fit Both 235/75-15 and 225/75/15 Tires
will these chains fit my 235x75x15 and 225x75x15 tires? | The Titan Chain Snow Tire Chains w/ Cams part # TC2819CAM that you referenced will fit your 235/75-15 tires but not your 225/75-15 tires. The reason for this is because the 235/75-15...
Tekonsha Voyager Light Not On When Leveling
I just installed a this 9030 voyager brake controller, and went to level it out per the instructions. When I set the gain to max, depress the brake pedal, and then slowly move the delay forward, I don’t get a change in the light color. It stays...
Filter Your Search
Contact and Help