Will Grease Seal GS2125DL Replace Seal that Measures .375 inch
My current seal has a thickness of .375inch and the replacement part GS-2125DL has .31. Does that matter? Also, the grease caps I ordered 2.44inch OD RG04-080 using the vehicle feature mode on etrailer does not fit my 6K lb Dexter axle. Those...
Will Dexter Nev-R-Adjust Electric Brakes K23-478-479 Fit 2013 Keystone Laredo W/ 4400lb AL-KO Axles
Looking for replacement brake assembly for AL-KO 9012 hub 4400 lb axle, thanks | I would be happy to help! The Dexter Nev-R-Adjust Electric Trailer Brake Kit # K23-478-479 you were looking at are the correct replacement brake assemblies for...
What Parts Do I Need To Install My New Tankless Water Heater With The Pressure Relief Valve In Back
My present hot water heater has the pressure relief valve venting out of the front of the unit. Thoughts on how to work the logistic of routing the vent plumbing from the back when replacing with a tankless unit? | You will use Camco RV Water...
Selecting The 3 Step or 4 Option of the TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear
When measuring the factory steps on my 2013 Keystone Laredo 329 RE, I definitely need the 27inch wide assembly. My question is whether I need 3 steps or 4. The height of the mounting bracket is 33inch when level on a concrete pad. I believe...
Reinforcing A Bumper On A 2015 Keystone Laredo 336TG
Please note my 2015 Keystone Laredo 5th Wheel model 335TGs rear bumper is only rated for 150 lbs. How do i mount this Cargo Carrier with a capacity of 500 lbs to bumper to ensure the bumper does not break away / fall off while in transport?...
How To Wire A 12V DC Tankless Water Heater In An RV That Previously Had A 120V Water Heater
I currently have a gas electric hot water heater. The electric is 120 volt. The tankless units are gas and 12V DC. Will I need to find or run a 12V DC source from somewhere or should there already be a 12V DC source at the present unit.? | For...
Availability of Dexter EZ Lube Spindle Nut 006-190-00
Do you stock the Dexter E-Z lube spindle nut retainer part # 006-190-00? I am ordering several other parts from you and I can not find this part. | We do have what you are looking for but it is our part number # 6-190. |
Troubleshooting Blwon/Melted Fuse for Landing Gear on a 2007 Keystone Montana 5th Wheel
I just replaced the gear reducer and installed new switch to raise and lower landing gear. When running the motor the wires got hot and burned out the 30 amp inline fuse on my 2007 Montana 5th wheel. | The best place to start looking when you...
Are The Econo Porch Trailer Step with Handrail and Landing # EHS-103-R Shipped Assembled?
I think these steps the Econo Porch Trailer Step with Handrail # EHS-103-would work for my 5th wheel as the height from ground to entry is about 30 inches. Does this come assembled? I have seen on other websites that these Econo porch with...
What is Needed to Pack Bearings on Trailer
I have a 2021 Keystone Laredo 325RL 5th wheel. What do I need to repack the bearings? I have never done this on an RV so once I start i want everything I need on hand | In order to re-pack the bearings on your trailer, all you will need is the...
Crank Extension and Crank for Lippert RV Spare Tire Carrier with Winch
Does the crank extension stay connected to the winch? If so, what keeps it from moving and banging around? If not, how does the crank extension connect to the winch? Thanks, 2017 Keystone Laredo 342RD 5th wheel. | The Lippert Components RV...
Replacement Bearings, Races and Grease Seal For Dexter 4,400LB Axle Under 2021 Keystone Laredo
I have a 2021 Laredo 255srl fifth wheel with Dexter axle no: 248744 of 4400 lbs and I would like to know the part numbers of the internal and external bearings, race complete set beauring, race, seal Thank you Jai une fifth wheel Laredo 255srl...
Recommended Cover for a 2019 Keystone Laredo 325RL 5th Wheel
I am in need of a storage cover that will fit and protect my 2019 Keystone Laredo 325RL. This is NOT a toy hauler. Length 36.67 feet 440 inches Width 8 feet 96 inches Height 13 feet 156 inches I do not know if the height includes the 2 AC...
Recommended Tankless Water Heater For 2018 Keystone Laredo Fifth Wheel RV
What tankless water heater would be recommend for A 2018 Keystone Laredo 5th wheel? Currently has factory installed gas/electric type model. | There are a few options when it comes to finding a tankless water heater for your 2018 Keystone Laredo...
Availability of Flush Mount Fireplace for 33" x 19-3/4" Opening
Can you help me find a rv fireplace that would fit into a 33 x 19 3/4 opening. Flush mount. thank you! | The closest fireplace we have to what you are looking for is the 34" Furrion RV Electric Fireplace with Logs # FF34SW15ABL which needs...
Troubleshooting 2010 Keystone Laredo 245RL Landing Gear Blowing Fuses
Hello, I have a 2010 keystone Laredo 245RL 5th wheel and just recently while trying to leave the camp ground the landing gear motor would throw 30 amp fuses while trying to raise the camper. The motor would run fine then slow down and blow...
Recommended Self Adjusting Brakes for 2014 Keystone Laredo 5W Travel Trailer
Need to replace the dexter brakes I have on my fifth wheel TT. Below is the part # the right hand set. I’d like self adjusting thanks Dexter backing plate part #023-463-00 | Based on your Dexter brake assembly information, it looks like you've...
Replacement Legs for Lippert Ground Control 3.0
5th wheel: 2018 Keystone Laredo 285SBH Need correct replacement part for lead leg component. Please advise | Can you let me know what landing gear set you have on your RV? I don't have a way to look that up so I would need you to get me that...
Could Wheel Masters Level Master 2 Trailer Bubble Level # WM67200 Install with Adhesive
Is there a way to attach this with adhesive. | I am sure you could use adhesive to attach the Wheel Masters Level Master 2 Trailer Bubble Level # WM67200 to your fifth wheel if you wanted to but we don't have an option for that. You could use...
Replacement Brake Shoes and Hubs for a 2012 K-Z Spree Escape Travel Trailer
I need to know what brake shoes part numbers and/or drums I need to replace old ones. I have a 2012 K-z spree E14RB. thank you | Sorry Russ but I have no way of knowing what brakes you have so I can't recommend the right replacement shoes....
Is The Correct Track Kit Compatible With Lippert Road Armor Equalizer On a 2021 Keystone Laredo
The RR23QX kit does this on a 2021 Keystone Laredo 255srl fifth wheel with Road Armor suspension with wet bolt in order to align the axles. Thank you Le kit RR23QX fait il sur une fifth wheel Keystone Laredo 255srl 2021 avec une suspension...
Recommended Self Adjusting Brakes for Al-Ko 4,400 lb Axles
I have a 2013 Keystone Laredo 5th Wheel 289SRE— I am looking for the self adjusting brakes and the drums for it. I’m thinking they’re 4400 pound axles. | Michael, so you are correct you do have 4,400 lb axles so you can use the Dexter Nev-R-Adjust...
How Are Old RV Waste Valves Removed
how do I remove old valve system??? | You have to cut off the old valves when replacing them like with the Double RV Waste Valves - Sanitation Tee - Rotating # T18A since the solvent used to install the valves creates a permanent connection....
Replacement Wiring Harness for Lippert Ground Control 3.0 System
Need a couple of the 3 pin connectors that goes in to the board where all the jacks plug in | The connector you sent in a picture of appears to be the wiring harness from a Ground Control 3.0 system like part # LC307490. We don't have a way...
Filter Your Search
Contact and Help