How Are Old RV Waste Valves Removed
Updated 07/19/2022 | Published 07/18/2022
Products Featured in This Question
Question:
how do I remove old valve system???
asked by: Michael L
0
Expert Reply:
You have to cut off the old valves when replacing them like with the Double RV Waste Valves - Sanitation Tee - Rotating # T18A since the solvent used to install the valves creates a permanent connection. For solvent to install the new valves we have the Valterra ABS Solvent Cement # A05-0303.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Double RV Waste Valves - Sanitation Tee - Rotating - 3" Spigot and 1-1/2" Hub
- RV Waste Valve
- Sanitation Tee
- Double Waste Valve
- 1-1/2 Inch Valve Body
- 3 Inch Valve Body
- Manual
- 1-1/2 Inch Hub
- 3 Inch Bayonet
- 3 Inch Spigot
- Rotating Valve
- Valterra
more information >
Continue Researching
- Q&A: Replacement for Lippert 289252D Leveling Control Module on a 2013 Winnebago Sunstar 35F
- Q&A: Looking for Replacement Control Module for Lippert Leveling System
- Q&A: Why is My New Watchdog Surge Protector Getting an E8 Error Code When Paired with Victron Multiplus?
- Q&A: Recommended Replacement AC System for a GE ARH15AACBL2 AC Unit
- Q&A: Recommended Tools For Removing Tight Sewer Drain Cap From Valterra RV Waste Valve
- Q&A: Recommended Trailer Hitch for a Ford F-53 Chassis W/ a 34" Wide Frame
- Q&A: RV Slide-Out Wiper Seal Replacement Guide for 2015 Tiffin Allegro Open Road 31SA
- Article: Trailer Tire Sizing
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Best RV Roof Vents
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: How to Accurately Measure Trailer Leaf Springs