!Liberty Travel Trailer  x   >   !Outback TT Toy Hauler  x   >   Mercury  x   >   Hopkins  x   >  

I have a 2008 Mercury Mountaineer. It is factory wired with a 4 pole flat connecter at the hitch. I want to install part #37185 so I can utilize the brakes on my camper. I have located the connector for the brake controller beneath the dash...

where do I connect the black wire from my vehicle ? | If the black wire on your 2001 Mercury Mountaineer is the 12V power wire from the vehicles battery you will want to connect that wire to the terminal at the eleven oclock position on the...

What if you have multiple wires for each connection? For example, 4 different brown wires reading 12v for tail light signals and two different wires each sending a 12v turn signal pulse for each side 2 per side, and so on. Application: 2005...

You list the hopkins 11140504 for a 2001 Crown Victoria but not for the Merc. Grand Marquis . Would this not work as they are corporate sisters and virtually all parts are interchangeable. | Although they may be similar, the Hopkins Plug-In...

Hi, What does class III mean? Need a hitch for my 2007 grand marquis. It has dual exhaust. Also, do I need to change it to single exhaust before I put the trailer hitch on? Havent bought the hitch yet. Am looking to buy the one your selling...

Hello, Purchased Hopkins 40475 kit and mounted everything properly to a 2007 Mercury Montego. Parking lights and turn signals work but No brake lights. I have tested with a multimeter at the receptacle on the Hopkins kit and there is no voltage...

So I ordered the hopkins 46255 for my 2004 Merc Grand Marquis. I am very familiar with wiring 12v. Everything is hooked up right, and works fine EXCEPT my tails. They did work one time for like, 10 seconds, and I cant get them to work when...

The cost and can a machanic install it. Weight capacity approximately. 3500 pounds. | I recommend the Curt Class II 1-1/4 Inch Hitch, part # C12232, for your 1997 Mercury Sable. This hitch has a maximum gross trailer weight capacity of 3,500...

my 2008 mercury mountaineer came from the factory with the socket under the dash for brake controller it has constant 12v power,and 12vpower when brakes applied, my question is there also wires going to the back of the vehicle for the electrical...

My 2004 Mountaineer is equipped with the 4 way connector and the small hitch from the factory. What would I need to convert to the round 7 way plug to utilize electric brakes on trailer? What wiring would I have to install if any on Mountaineer...

After installing part #40455 and hooking up my trailer, the only lights that work are the lights that come on at night/when my headlights are on. Brake lights and turn signals dont work. Do you think I just got a faulty part? | Vehicles using...

2010 mountaineer class 3 hitch installed by Curt. Put a 7 pin wire plug in. Purchased the factory wire harness plug from the brake Prodigy. Do I need to run the wire from the brake controller to the 7 pin Wire plug. Or did Mercury install...

Do you have specific instruction to install the N46255 Hopkins Active Tail Light Converter with Install Kit on a 2011 Mercury Grand Marquis? If available, please send me a link. | Universal trailer wiring harnesses such as # 46255 do not have...

Does the RN76511 also work on the Ford Edge 2011. If so when I tow my car on a dollie will the rear lights all work off the towing truck and not effect the cars elictrical system. | Yes, the Roadmaster FuseMaster Fuse Bypass, # RM76511, will...

Hello, I have a 2007 mercury mountaineer premier v8. It has a 1 1/4 hitch in the frame with a flat 4 wire connector. I have a class 3 hitch that I am installing underneath the existing class 2. I need to switch to a 7 wire connector as well....

Is it possible for the mercury Mountaineer 1999 have 2 plugs. Under the rear bumper there is 1 on each side. Can I use either one of these? | On 1999 Mercury Mountaineers that came with a factory tow package the connector you need will be the...

I have a 2004 Mercury Grand Marquis Ultimate addition with fully digital dash I had a local trailer wiring dealer say their is no application for this vehicle and ford claims the same and basically you can not tow with this vehicle.Does your...

I Have a V8 Mountaineer with the 1 1/4 inch hitch. I’m picking up a hybrid camper that has a gross weight of 2800lbs. I was planning on upgrading from the 4 pin connecter to a 7 pin and running a brake controller. Do I also need to upgrade to...

How do I find out if my 2006 mercy mariner has towing package | The best way to find out if your 2006 Mercury Mariner has a factory tow package is to have the dealership run the VIN number of your vehicle. They will be able to tell you all the...

I am looking at buying a 2003 Mercury mountaineer V8 that has a factory 1 1/4 inch receiver on it. I need to tow a boat with this vehicle. Is it ok to use an adapter to step the 1 1/4 up to a 2” reciever? Please advise ! I am a loyal customer...

I have a factory tow package installed but the relay box in the rt. 1/4 panel is missing the wiring that the relays should plug into. The plug at the hitch is a 7 plug round and the harness is factory stock. verified by dealer Have you ever...

Will this hitch be compatible with my 1998 Sable dual-exhaust model? None of the pictures or installation instructions mention this specific model. | I spoke with my contact at the manufacturer to make sure there were no issues with the factory...

ok in my 2002 mercury mountaineer i am trying to connect my boat trailer but i am not getting the 12 volt at the adopter that come attach to the suv is a 7 way plug the only 12 volts i am getting is went i put my head lights on... i am using...

I have a 1999 Jeep Grand Cherokee that I tow behind my Class C motor home with a Roadmaster Stowmaster 5000. I am looking at trading the Jeep for a 2009 Mercury Mariner. What do I need to adapt the tow bar to the Mariner? | To attach the Roadmaster...