Replacement Windshield Wiper Blades for 1997 Lexus LX 450
Why is one 16inches and one 18inches when both should be 18? 1997 lx 450 is the vehicle. is the scrubblade bigger? and has clearance issues? | Actually, Scrubblade recommends the # SC87FR 18 inch blade for the driver side and the # SC67FR 16...
Installing the Hopkins Smart Hitch Backup Camera on a 2013 Ram
I have this camera but it doesnt work on my 2013 Ram. Why not? | We have learned that the 2013 and newer Ram trucks do not provide enough voltage to power the Hopkins Smart Hitch, part # HM50002, simply by plugging it in to your truck. In...
Left Signal on Trailer Flashes when I Indicate Right Turn
I have a 96foot LX450. When I signal a left turn all works as it should. When I signal right, the lights on the right side passenger side of the trailer go out and the left turn signal blinks on the trailer. All the lights work properly on...
Recommended Tire Chains For Off-Road And Snow Use On 1996 Lexus LX450
Please recommend snow tire chains for my 1996 LEXUS LX450. The truck has a 2inch lift for additional ground and tire clearance. Tires are Goodyear Wrangler Duratrac 265/75-16. The chains will be used on four wheels on snow and ice covered paved...
Draw-Tite VS Curt Class III Receiver
I have a 1997 Lexus LX450 with the Draw-Tite Class III receiver installed. It has been there for quite a while and is has rusted so I thought it was time to replace it. I would like some information on Draw-Tite vs Curt for the class III receiver....
What Size Dowel Nuts Do I Need for My Vehicle?
Where can I find the dowel nut replacement bolt for gutter mount. Its for an 1996 landcruiser | We do have plenty of replacement dowel nuts like the Replacement M6 x 16 mm Dowel Nut for Rhino-Rack Accessories # RR56TB which are M6 x 16 mm threaded...
Do Factory Bump Stops have to Be Cut to Install Air Lift Air Bags on a 1997 Lexus LX450
Hi! Do I need to hack off part of the bump stop for this installation? Please send install procedure specific for a 1997 Lexus LX450. | Yes you will need to trim away the factory bump stops to install Air Lift helper springs # AL60728 on your...
Bearing Kit that Works for 2007-2010 TADA Dutchmen for the Al-KO Axle
This is the bearing kit others have used for the 2007-2010 TADA Dutchmen for the Al-KO Axle. The specs are as follows: Trailer Bearing Kit Consists of: 1 - A17 Bearing Set L68149/L68111 1 - A4 Bearing Set L44649/L44610 1 - 442251 Seal 1 -...
Brake Controller Installation on 1997 Lexus LX 450
looking for a Prodigy direct plug in wiring harness for a 1997 Lexus LX450. Do they make one or do I have to use a universal and wire it myself? | The 1997 Lexus LX450 was not factory equipped with the connector under the dash for a plug and...
Can The 7-Way Trailer Connection Be Used To Power Winch If Vehicle Is Running
Can the 7 pin plug be used to power the winch if I have my truck running? | The wiring that feeds the 12-volt accessory circuit on the 7-way trailer connector is of too small a gauge to allow enough power to pass through to run a winch. The...
What is the Distance between the Pinhole and the Outside Wheel Hoop of the Traveler XC2 # S64663?
Trying to determine the distance between the hole on the hitch receiver to the farthest distance from same. | I confirmed with my tech at Swagman that the distance between the center of the pinhole to the outside edge of the furthest wheel hoop...
Filter Your Search
Contact and Help