What Do MORryde StepAbove RV Steps part # MR28RR Weigh
WHAT IS THE ACTUAL WEIGHT OF THE STAIRS | Hey Don, so the MORryde StepAbove RV Steps part # MR28RR weigh 61 lbs. Side note they have a 500 lb weight capacity. |
Can The 7-Way Trailer Connection Be Used To Power Winch If Vehicle Is Running
Can the 7 pin plug be used to power the winch if I have my truck running? | The wiring that feeds the 12-volt accessory circuit on the 7-way trailer connector is of too small a gauge to allow enough power to pass through to run a winch. The...
Brake Controller Installation on 1997 Lexus LX 450
looking for a Prodigy direct plug in wiring harness for a 1997 Lexus LX450. Do they make one or do I have to use a universal and wire it myself? | The 1997 Lexus LX450 was not factory equipped with the connector under the dash for a plug and...
Left Signal on Trailer Flashes when I Indicate Right Turn
I have a 96foot LX450. When I signal a left turn all works as it should. When I signal right, the lights on the right side passenger side of the trailer go out and the left turn signal blinks on the trailer. All the lights work properly on...
Replacement Windshield Wiper Blades for 1997 Lexus LX 450
Why is one 16inches and one 18inches when both should be 18? 1997 lx 450 is the vehicle. is the scrubblade bigger? and has clearance issues? | Actually, Scrubblade recommends the # SC87FR 18 inch blade for the driver side and the # SC67FR 16...
Draw-Tite VS Curt Class III Receiver
I have a 1997 Lexus LX450 with the Draw-Tite Class III receiver installed. It has been there for quite a while and is has rusted so I thought it was time to replace it. I would like some information on Draw-Tite vs Curt for the class III receiver....
Installing the Hopkins Smart Hitch Backup Camera on a 2013 Ram
I have this camera but it doesnt work on my 2013 Ram. Why not? | We have learned that the 2013 and newer Ram trucks do not provide enough voltage to power the Hopkins Smart Hitch, part # HM50002, simply by plugging it in to your truck. In...
Do Factory Bump Stops have to Be Cut to Install Air Lift Air Bags on a 1997 Lexus LX450
Hi! Do I need to hack off part of the bump stop for this installation? Please send install procedure specific for a 1997 Lexus LX450. | Yes you will need to trim away the factory bump stops to install Air Lift helper springs # AL60728 on your...
Can Lippert Center Point LC1565391 be Used with 6k Rated Axles
It states for axles up to 8k, my question my trailer has 2 6k axles, normal trailer weight is right at 10,500 lbs. My question is this rated up to 16k on a pair of 8k axles or is only good for up to 8I total weight. | The Lippert Center Point...
What Size Dowel Nuts Do I Need for My Vehicle?
Where can I find the dowel nut replacement bolt for gutter mount. Its for an 1996 landcruiser | We do have plenty of replacement dowel nuts like the Replacement M6 x 16 mm Dowel Nut for Rhino-Rack Accessories # RR56TB which are M6 x 16 mm threaded...
Recommended Tire Chains For Off-Road And Snow Use On 1996 Lexus LX450
Please recommend snow tire chains for my 1996 LEXUS LX450. The truck has a 2inch lift for additional ground and tire clearance. Tires are Goodyear Wrangler Duratrac 265/75-16. The chains will be used on four wheels on snow and ice covered paved...
Can Hitch Weight of Fifth Wheel Setup be Moved Forward by Adjustments to Hitch
I have had my hitch for a couple years, have run over the scales, and what I see is 3600 lbs pin weight, but only 75 lbs transfer to the front axle, 2006 ram 2500 crew cab short bed, turn over ball, have the hitch as far fwd as the mounts will...
Filter Your Search
Contact and Help