Wiring Harness For Installing a Hayes Engage Trailer Brake Controller On 2012 Cadillac Escalade EXT
what wiring harness do I need for my 2012 Cadillac escalate ext and 81760 controller | To install the Hayes Engage Trailer Brake Controller # HA81760 on your 2012 Cadillac Escalade EXT you will need the Universal Wiring Adapter # HA81789-HBC....
Can The 7-Way Trailer Connection Be Used To Power Winch If Vehicle Is Running
Can the 7 pin plug be used to power the winch if I have my truck running? | The wiring that feeds the 12-volt accessory circuit on the 7-way trailer connector is of too small a gauge to allow enough power to pass through to run a winch. The...
Installing the Hopkins Smart Hitch Backup Camera on a 2013 Ram
I have this camera but it doesnt work on my 2013 Ram. Why not? | We have learned that the 2013 and newer Ram trucks do not provide enough voltage to power the Hopkins Smart Hitch, part # HM50002, simply by plugging it in to your truck. In...
Do Factory Bump Stops have to Be Cut to Install Air Lift Air Bags on a 1997 Lexus LX450
Hi! Do I need to hack off part of the bump stop for this installation? Please send install procedure specific for a 1997 Lexus LX450. | Yes you will need to trim away the factory bump stops to install Air Lift helper springs # AL60728 on your...
Does Superchips F5 Programmer from 2010 GMC Yukon Fit 2002 Cadillac Escalade EXT
Will my tuner Super chip F5 that I used on my 2010 gmc yukon work on my 2002 Escalade ext | Yes the same Superchips F5 programmer part # SU2845 fits both the 2010 GMC Yukon and the 2002 Cadillac Escalade EXT. You will have to remove the tune...
Draw-Tite VS Curt Class III Receiver
I have a 1997 Lexus LX450 with the Draw-Tite Class III receiver installed. It has been there for quite a while and is has rusted so I thought it was time to replace it. I would like some information on Draw-Tite vs Curt for the class III receiver....
Recommended Front Mount Hitch for a 2003 Cadillac Escalade
Do you have a high clearance front hitch for a 2003 Caddy escalade ext. I would prefer it at the licence plate height and not below the bumper. Please let me know. Thanks | No, we do not and I checked with our vendors there isn't one out there....
Brake Controller Installation on 1997 Lexus LX 450
looking for a Prodigy direct plug in wiring harness for a 1997 Lexus LX450. Do they make one or do I have to use a universal and wire it myself? | The 1997 Lexus LX450 was not factory equipped with the connector under the dash for a plug and...
What Size Dowel Nuts Do I Need for My Vehicle?
Where can I find the dowel nut replacement bolt for gutter mount. Its for an 1996 landcruiser | We do have plenty of replacement dowel nuts like the Replacement M6 x 16 mm Dowel Nut for Rhino-Rack Accessories # RR56TB which are M6 x 16 mm threaded...
Correct Replacement Bearings for Boat Trailer with Oil Lubrication Hubs
I have a 2007 talb 23-27 7900lb trailer and looking for bearing kit. it is an oil based NOT a grease based lubricant system. | I do have options for you but we can't look up bearings for any one specific trailer, you'll need to find the axle...
Replacement Windshield Wiper Blades for 1997 Lexus LX 450
Why is one 16inches and one 18inches when both should be 18? 1997 lx 450 is the vehicle. is the scrubblade bigger? and has clearance issues? | Actually, Scrubblade recommends the # SC87FR 18 inch blade for the driver side and the # SC67FR 16...
BAK Flip F1 Tonneau Cover that Fits 2002 Cadillac EXT Escalade
will this retro-fit into a 2002 Cadillac EXT pickup | The BAKFlip F1 Hard Tonneau Cover # BAK72108 that you referenced is a confirmed fit for your 2002 Cadillac EXT Escalade and would easily fit without any modifications to the vehicle or the...
Left Signal on Trailer Flashes when I Indicate Right Turn
I have a 96foot LX450. When I signal a left turn all works as it should. When I signal right, the lights on the right side passenger side of the trailer go out and the left turn signal blinks on the trailer. All the lights work properly on...
Does Replacement Lock Cylinder for BOLT Toolbox Latch # BL692918 Fit 2003 Cadillac Escalade EXT
I ordered the BL692918 tonight will it fit my 2003 Cadillac Escalade EXT | Yes, the Replacement Lock Cylinder for BOLT Toolbox Latch # BL692918 that you referenced will fit the key you have for your 2003 Cadillac Escalade EXT. |
Which Replacement BOLT Lock Cylinder Fits 2003 Cadillac Escalade EXT
Will this fit a 2003 Cadillac Escalade EXT | The BOLT lock cylinder that works with the key of your 2003 Cadillac Escalade EXT is the part # BL692918 as the lock cylinder you mentioned would fit a newer model. |
Recommended Tire Chains For Off-Road And Snow Use On 1996 Lexus LX450
Please recommend snow tire chains for my 1996 LEXUS LX450. The truck has a 2inch lift for additional ground and tire clearance. Tires are Goodyear Wrangler Duratrac 265/75-16. The chains will be used on four wheels on snow and ice covered paved...
Does Topline Tailgate Extender part # BX4004-02 Fit 2004 Cadillac Escalade EXT
Will it fit on 2004 cadillac escalade ext | Yes, Topline has confirmed for us that their Fold Down Truck Bed Expander # BX4004-02 does fit your 2004 Cadillac Escalade EXT. I attached a review video for this for more info for you to check out...
Vehicle Fits for Curt Class V Hitch C15324
IT dont fit right it wont tighten all the way up to the frame ?? its like its to short hit the bumper wont tighten up ?? | Curt Class V hitch # C15324 is designed to install on your 2003 Cadillac Escalade EXT without any trimming so it should...
Recommended Weight Distribution System with Sway Control for a Winnebago Micro Minnie 2106FBS
Can I safely tow a Micro Minnie 2106FBS with a 2011 Cadillac Escalade EXT that is AWD? If so, please recommend best anti sway hitch. Thanks! | The weight distribution system with integrated sway control I recommend for a Winnebago Micro Minnie...
Filter Your Search
Contact and Help