Where Does Air Bag of Air Lift Kit # AL89215 Install on 1986 Ford F-250
1986 Ford F250 JD 4x4 89215 There are pictures of installation between frame and jounce base beside spring. Installation instructions show upper mount offset towards outside of frame and over leaf spring. What do the picture installation relate...
Can Journey Hyndsight Observation System # JVS-EW See in Low Lighting
What is the low light operational capabilities of this camera? What is the lowest light level images will be viewable on this system? How dark until images are not viewable? Thanks.. | I tried to get more info on the low light capabilities...
Front Hitch for 1986 Ford F-350
Will this hitch fit the front of my 86 F350 2 wheel drive, crew cab dually ? | The B&W Heavy-Duty Trailer Hitch # BWHDRH25122 that you referenced is confirmed to fit your 1986 Ford F-350 Dually, but it's designed to install onto the frame...
Dimensions of Air Bag of Air Lift Kit AL88203
Do you have dimensions of the airbag itself and the lower bracket ? I have the old Jet Air ride system installed but do not want to go through the mess of removing and replacing the bags especially as they are holding air. So I want to leave...
Are There Installation Instruction for the Curt Gooseneck Plate # C65500
I bought this universal hitch some time back but lost the instructions. Can you tell me please, is it a certain measurement specification for what you are pulling or is there a common measurement that is basic depending on my pick up? | The...
Parts Needed to Install Tekonsha Brake Controller in 1986 Ford Bronco with 4-Way
I need a 7-pin connector and brake controller for a 1986 Ford Bronco. I currently have a 4 pin connector installed. What equipment do I need to purchase to make this transition? My other vehicle has a Tekonsha brake controller and I like that...
How would Two Batteries Get Wired for 12 Volts on Honda Goldwing
how should i run 2 batteries on my 1986 special edition 1200 cc sei motorcycle it has a car hed unit in it and i want to be able to run a 1000 what car amp and 2 10 inch subs on the bike how do i set this up i have the amp and going in the...
How to Install Erickson Retractable Anchors EM01003 in F-150 with Factory Bed Liner
Can this anchor be installed in the stake slot from above, without having to access it from below?...the factory bedliner is already installed in my 86 F150. Thanks | The Erickson Retractable Tie-Down Anchors # EM01003 do install in your F-150...
Recommended Extension Cord for Badlands Winch Hidden Behind a Bumper
I was looking for something similar to the extension you sale for the ComeUp winched, but for a Badlands winch that is hidden behind the bumper. Do you know if you have anything compatible? | It sounds like you're looking for the Extension...
Troubleshooting Remote Not Working with MaxxFan Plus Roof Vent # MA00-04000K
Remote won’t open vent or start the fan. No operation from remote either manual or remote | If your MaxxFan Plus Roof Vent # MA00-04000K isn't responding at all to the remote then most likely it just needs to be replaced with part # MA00A01150K...
Troubleshooting Green Light on Display of Tekonsha Voyager 39510 All the Time
Is the green light on controller suppose to stay On all the time | The green light on the display of the Tekonsha Voyager part # 39510 indicates that a trailer is connected. If you are seeing this all the time on the controller that would indicate...
Hitch Recommendations for a 1986 Ford E-350 Box Truck
just measured the frame on my 1986 e350 box truck. its 39.5foot center to center, will the 14053 fit my truck? please call me at the shop. | I spoke with my contact at Curt and he informed me that the distance between the bolt holes centers...
Buyers Products Gooseneck Safety Chain U-Bolt Kit Dimensions
How long are these u bolts I have a 1 inch plate under my bed I want to make sure they are long enough | The Buyers Products Gooseneck Safety Chain U Bolt Kit # 337BRB03 has an overall length of 5-5/8 inches and a length of 4-3/4 inches that...
What is the Inlet and Outlet Diameter of MagnaFlow Spun Stainless Catalytic Converter Part MF54956
whats the in/out size of this cat? | The inlet and outlet diameter is 2-1/2 inches. This Catalytic Converter is 49-state approved. It is not approved in California. |
How To Mount Westin Fey Diamondstep Rear Bumper On 1986 Jeep Comanche
will the Westin Fey Diamondstep Rear Bumper - Black Powder Coated Steel Item # 63000, fit a 1986 Jeep Comanche? why only 87 and up, what is different about the 86 that would make it not work? Thanks for your help. | The Westin Fey Diamondstep...
Parts Needed To Install RV Curtains
Hello, I am looking to purchase everything I need to install snap curtains on a rv that currently has nothing on the walls at all. I need track, and the slides for the track plus the tape to sew onto a new set of curtains I am making myself....
How to Wire in an Electric Trailer Brake Controller Pulse Preventer
I have a 1986 Ford f350. I spliced into the cold side of the brake switch, keeping the original brake wire traveling to the brake lights. So now.... Question Do I conect the Yellow wire to the cold side brake wire. and the brown wire to the...
Troubleshooting 5-Way Trailer Connection on 1986 Jeep Grand Wagoneer
I would like to use the OEM wiring harness that is at the back of the vehicle. It is a flat 5 plug, but is quite a bit longer than the flat 5 trailer plugs that I’m finding at the auto parts stores. The pins are spread out more on my Jeep...
Recommendation For A Hidden Hitch For A 1986 C-10 Shortbed Truck With a Regular Bumper
Looking for a hidden hitch. | The Draw-Tite Class III Max Frame Hitch # 75034 that you referenced will work for your 1986 Chevy C-10. The hitch is designed for the 6 foot shortbed C-10 with the the standard or step bumper and is the replacement...
Will Curt Hitch Fit 1986 Chevy Short Bed Pickup
Hi I am looking at the 13028 for a 1986 Chevy pickup short bed. It says it will match but the holes dont really line up on the mounting bracket. Can you check me on this before I order? Thanks | The Curt # 13028 is designed to fit the 1981 -...
Flat Tow Setup For A 1986 Suzuki Samurai
I have 86 suzuki samurai I want to flat tow. Im looking at RM-501 and 1003-1. Are those compatible and is the 910021-00 necessary for this set up? Or is there a better set up for around? | If you're wanting to use the Roadmaster StowMaster Tow...
Suspension Enhancement System for a 1986 Chevrolet P-30
Do you carry firestone ride- rite air bags for 1986 Chevrolet p- 30? I need front and back.. | We do have Firestone Ride-Rite air bags available for a 1986 Chevrolet P-30. They are the Firestone Ride-Rite Air Helper Springs # F2080 for the...
Will The Westin Fey Diamondstep Rear Bumper # 63000-97900 Fit A 1986 Comanche
I was wondering if it would fot on a 86 long bed says it only fits 87-92 but is there a completely different mounting bracket i would need to make this fit? Or is there no chance at all I’m getting it on there? | Your 1986 Jeep Comanche is not...
Bolt Hole Spacing of Curt Class IV Hitch Receiver 14082
Curt c14082. Is there a diagram with specs. Trying to find out the distance between frame mounting holes. Kinda like this pic but for the hitch. | From side to side, the mounting holes measure 31-1/4 inches apart, center to center. All three...
Filter Your Search
Contact and Help