Result:

Have a 2025 heartland corterra 3.0 5th wheel. 10,500 dry. how much weight can be out on a stack | Hello Tom, Congrats on the new 2025 heartland corterra 3.0 5th wheel, what is your favorite feature? I cannot find the exact weight anywhere...

Is there anything taller than this? I have my tongue jack fully extended with over 8inch of blocks under the jack and still having a hard time removing my WDH bars. | I have a solution for you, but the Valterra # A10-0900 is going to be the...

I have a class A motor home with hydraulic leveling system, looking for blocks to put under the leveling pads to distribute the load over wider area when on black top or softer ground. What would be a good choice? | I have exactly what you will...

What is the weight capacity of these pads | Hey Kevin! Stackers StayPut Jack Pads and Leveling Blocks # VAL33MB are rated for up to 15,000 lbs per tire or jack. They’re designed for use under RV jacks, landing gear, and tires to help distribute...

I recently bought the 6 point Lippert System for my 2005 Weekend Warrior 40 Fifth Wheel Toy Hauler. I was able to install it with some custom brackets and installing the electric motors above the floor. Now I need legs or extra blocks.... The...

I need an A Frame bolt on side wind 5000lbs manual trailer tongue Jack. There are several choices, but I need one that is durable, reliable, and long lasting. The one that came on my travel trailer only lasted 2 1/2 years, and failed on a...

How tall is one complete set of RV Jack Pads? Inches? | Hey Megan. Each of the StayPut Jack Pads and Leveling Blocks item # VAL93MB measure 1-3/8" tall. The 10-pack when stacked together will be 13-3/4" tall. They're each 10" long x 10" wide...

Hi, what would you recommend for our tires 2022 Keystone Passport travel trailer. We keep our camper at home but would like to elevate the tires from the dirt. Thank you. | Hi Susan! There are a few ways to get the tires on your 2022 Keystone...

Can these levelling pads be used sideways to support dual wheels in an RV? Thanks, Joseph | Hey Joseph, the Stackers StayPut part # VAL33MB can work for you but you don't want to use them rotated like you mentioned. You just want to use them...

I have a 22.5 ft, 3900 dry weight travel trailer and find backing it on to leveling blocks very difficult. If I use 4 leveling jacks, one for each corner, would I still need to use leveling blocks? | The # UF48-979002 feature oversized footplates...

Got an out a stroke code. Says that they have been extended to far, but it’s on fairly level ground | If you're getting this error then you'd want to use more blocks, like part # A10-0918, so that you won't have to extend the legs of your Lippert...

How thick are these pads? | Hey Matt, the Stackers StayPut Jack Pads # VAL33MB are 1 3/8" thick. | Hey Matt, the Stackers StayPut Jack Pads # VAL33MB are 1 3/8" thick. Feel free to let me know if there's anything else I can do for you. |

Our 2014 Columbus 320rs auto leveling device is show a message: Error—- out of stroke. We do not have truck here so we canno hook up. Rv needs to auto leveler to work- is not level now. Do you have any advice. I’m afraid to punch again....

I was wanting to know which blocks you would recommend for a 40ft fifth I generally put one solid cement block on each leg in front and I have two solid cement blocks on each of the back, I like your extreme you sell not sure if they can hold...

I noticed that the one video showed using the blocks under only one axel. Isn’t it bad to shift all of the weight from the two axels on to the one axel? | I believe you're talking about the video I have attached of the Stackers Leveling Blocks...

Can 2x10 wood pieces normally used under most stabilizing jacks be fastened to the Lippert Power Stabilizer Jack feet to keep the feet from sinking into the ground? It would be nice not to have to stow extra wood when travelling. | Lots of RVers...

Do you need a jack to use the stackers | The Stackers part # A10-0920 can be used under jacks/stabilizers but can also be used under the wheels of a vehicle to level. I attached a picture that shows this as well. |

I have a 2003 GMC Sierra 2500 HD standard bed pickup with a Four Wheel popup camper installed. I have two 17 foot long sea kayaks I would carry on the roof of the camper with the roof down . The camper has a Yakima rail system with round crossbars....

I see a similar question answered stating a linked video that I do not find. I see regular video but I need to see how it can work when there is no room for a needed 2nd set on double axle 5ers rear axle. With them being 15inch long and 4inch...

Will these plates fit on standard TT scissor jacks? | I do have an option for you but the Ultra-Fab Footplate for Landing Gear and Stabilizer Jacks part # UF17-940006 are made for landing gear legs, not scissor jacks. That said, they don't really...

I bought the stacker blocks A10-0920, for my fifth wheel. What is the max weight for each block. Im using 4 of them for leveling purposes. | Whether you are using just 1 or all 10 of the Stackers Leveling Blocks # A10-0918 the maximum capacity...

Hi, I would like to buy some Leveling blocks, but I was hoping you had a size that was a bit wider. Do you have anything wider then 8-1/4? About 12 to 16 The one I saw on your website is Item # UF48-979052. If you do have something wider...

Regarding product Item # A10-0917, the description sounds like it is 4 inches tall but nothing else confirms that. are these just singles of the 8x8x1.5 or are these actually taller? Is so, what are the pad dimensions? Thank you. | The Stackers...

For part # A10-0916, how much lift will be given for each block. It states they are 4inch tall. So that means each block would provide 4 inches of lift? And two blocks would give 8inch of lift? If so, this is exactly what I am looking for. Thanks...