Result:

Will your universal step for my truck? Desperately need some kind of a step because of leg problems. | Yes, the universal Pilot Aluminum Step part # AS-400 will install on your 2008 Ford Ranger. It installs on the frame on the driver's-side...

do you carry a tailgate tail light bar that will fit my 2003 ranger? please note that the spare tire lowering device is between the bumper and tailgate in the center | You will be able to use the Universal LED Tailgate Fire Strip Brake, Tail...

Hello, I have 2024 Ford Ranger Raptor and was wondering if this would fit since i have the raptor? Part RAS29VR. Was also wondering if they have air bags instead. I have a trailer that’s 4,500 pounds that i haul and I’m looking to get more stability...

2011 Ford Ranger XLT 2WD, 4.0 V6, w/ ARE fiberglass cap, 55K miles. I already installed the RAS system last week. However, in my long wait for that suspension upgrade I also ordered the Timbren part # TFRR050A. So my question is this. Is using...

We are wondering if the black bull side step would fit on our 1992 ford ranger single cab. Appreciate you time and help. | The Bully Black Bull Side Steps that you referenced, # BBS-1103, are not a fit for your 1992 Ford Ranger. We do have...

I have a 1999 Ford Ranger with a camper shell on it. Will this rack work for my truck? If not, do you have something similar that will? Thank you | The TracRac CapRac Ladder Rack for Camper Shell/Truck Cap # TH29200XT is the only confirmed fit...

I need advise on setting up my 2002 Ford Ranger 2WD, 3liter engine, for a better suspension for Towing a Trailer. What do you recommend for Air Bags and other changes that are adjustable for a better Towing suspension upgrade. Thanks. | The...

What is the procedure to attach these? Any drilling needed? | The Pilot Aluminum Universal Side Step Bar # AS-400 installs on the rocker panel of your 2002 Ford Ranger Edge Extended Cab. Since it is a universal step there aren't any generic...

I have a 4 prong male connector attached to the bumper. Is there an adaptor or other connection I can make to have the lighted bumper step connect to my brake, tail lights and signals? | I went outside and tested the Round Tube Stainless Steel...

will this latter rack work with a toolbox mounted in truck for a 1998 rord ranger | The Pilot ladder rack # CG-902 is a good option, possibly even the best option. The brackets will mount to the tops of the bed sides so your toolboxes can...

Will the pilot CR-007 work on a 2021 ford ranger xlt. | The Light-Up Rectangular Trailer Hitch Receiver Cover part # CR-007 is a universal mounted hitch light that gets power from the 4-way. It works on most vehicles but we aren't able to offer...

My truck is s 2000 Ford Ranger that does not have yellow turn lights. Do I need some type of adaptor other than my factory four prong? | You will be able to use the Universal LED Tailgate Fire Strip Brake, Tail and Turn Lights, # TLB-001, on...

Will these step fit a 1998 ranger regular cab 2 wheel drive truck | As long as you have access to the rocker panel then yes, the Pilot Aluminum Universal Side Step Bar # AS-400 will fit. This is a universal application and we haven't fit it...

What are the dimensions adjusted in and out wide I have 58inch inside bed rails | The Bully Adjustable Ladder Rack part # CG-902 has been confirmed as a fit for your 6 foot bed 2008 Ford Ranger that has 58 inch wide bed rails. It can be adjusted...

What width range of adjustability does this have, how narrow can it go? | I contacted Pilot Automotive and found that the width range of the crossbar with the Bully Adjustable Ladder Rack for Full-Size and Compact Trucks # CG-902 is 42-1/2 to...