Result:

I am looking for a slide motor replacement for Power Gear p/n 520430. I cant find it. Is there a direct replacement? This is from a 2000 Damon Intruder. | Hey Dennis, I spoke with Lippert and found that the Replacement Gear Motor Assembly...

Hello, I have 2024 Ford Ranger Raptor and was wondering if this would fit since i have the raptor? Part RAS29VR. Was also wondering if they have air bags instead. I have a trailer that’s 4,500 pounds that i haul and I’m looking to get more stability...

I have the Lippert pump assembly 646822 which has been replaced by 731445. I do not need the whole assembly. I only need the pump and the part that is in-between the pump and reservoir. the reservoir and reversing solenoid are both good. ...

I have a 2016 R-POD 178 camper and would like to know the correct awning that will fit it and the cost. THX Dave | We can recommend items for a (our shortest width) 10' width awning or larger widths, but there really isn't a specific awning...

My slide-out measures 138 1/2 from out side of flange to outside of flange. Which black slide-out cover do you recommend? | For a 138-1/2" flange to flange measurement I recommend the Solera RV Slide-Out Awning - 139" Wide - Black # LCV000168328....

Looking for axle riser fo Rpod 2017 model Rpod 178 model | Since we know your R-Pod is newer than 2014 we know that your have the Lippert torsion style axles which means there are two different lift kits that will potentially fit. You will...

I have 2019 Surveyor travel trailer by Forest River. It has factory installed Lippert Electric stabilizers front and back not scissor jacks on each corner. What JT Strongarm do I need to order? Thanks | For your 2019 Forest River Surveyor...

Hello, I have a slide out that measures 167 and 3/8 inches flange to flange. Would you recommend a 173inch slide topper? | Either will be a good fit, it comes down to personal choice of how much overhang would you like and if there is the...

Looking for a easy install Trailer Electronic stability control. Tuson, Lippert Sway Command, or Hayes For use with the Redarc TowPro on a 2021 Ford Ranger and 2021 Winnebago Micro Minne | We don't carry the Hayes system, but I can explain the...

when I remove the waste master hose for storage I need a cap to close end of hose. I also would like to have a better solution than little red stopper on exit end. I know I have the shut off but once as I was unpacking hose the shut off got...

2011 Ford Ranger XLT 2WD, 4.0 V6, w/ ARE fiberglass cap, 55K miles. I already installed the RAS system last week. However, in my long wait for that suspension upgrade I also ordered the Timbren part # TFRR050A. So my question is this. Is using...

Im looking for a 6 Ball Mount that would allow the addition of a second receiver for a bike carrier. I was looking at the Curt Multipurpose Ball Mount, but it appears to only be available in a 2 . Are there any other similar options for...

Hi, please can you tell if this works with 18v arms? Thanks | Yes, the Solera Awning part # LCV000211513 that you referenced can be used with 18 volt powered awning arms like the Solera 18V Power RV Awning Conversion Kit # LC434729. |

Can just the rubber cushion be replaced or do you have to replace the shackle. THe rubber on mine are gone the the shackle apears to be in good shape. | I checked with Lippert and the rubber cushioning cannot be replaced individually. If that...

I need advise on setting up my 2002 Ford Ranger 2WD, 3liter engine, for a better suspension for Towing a Trailer. What do you recommend for Air Bags and other changes that are adjustable for a better Towing suspension upgrade. Thanks. | The...

Can you please tell me what the measurement is for the overall depth of the step assembly when it is in the vertical position? Also, can I not purchase an extra step? If not, what would I do if one got damaged? | At it's widest point, including...