Result: Step Support

Upon reading all the information, I do agree with you and believe the controller to be the issue. For your Replacement Steps, Motor, and Control for Kwikee RV Electric Steps # LC3722615, the correct replacement control module is the: -Replacement Control Unit for Kwikee Electric RV Steps # LC379146. |

This is because the handrail will use mounting brackets specific to the TorkLift step design. In order to use this with the electric steps on your Holiday Rambler RV, you would likely need to extend the vertical rail down to the ground with a rubber foot. |

| With the truck step inserted into a trailer hitch the support arm will sit 1-5/8 inches below the hitch receiver opening and the support arm will extend under the vehicle 22-1/2 inches from the front of the hitch receiver, when it is completely retracted under the vehicle. |

| The Replacement Step, Motor, and Control for Kwikee RV Electric Steps part # LC3747452 comes with the Replacement Control Unit for Kwikee Electric RV Steps part # LC379146. |

Yes, the Replacement Gear Box and B Linkage for Kwikee Electric RV Steps # LC379161 is confirmed to fit series 28 steps on your 2000 National Seabreeze Motorhome. | Does this fit a series 28...

From the bottom of the ladder to the bottom of the first step on RV ladder # SP502L is approximately 10 inches. | what is the measurement from bottom of ladder where it attaches to trailer and bottom of 1st...

You are correct. The Scissor Steps # SS03 that you referenced could easily be removed from the mounting bracket that gets attached to the RV or wherever you mount it. | With regards to the #SS03 Scissor Steps,...

This would be my choice, but if there is not enough overhang, then step down to the Solera RV Slide-Out Awning - 14'1" wide with a 48" projection, # LCV000163302 for white or # LCV000168112 for black, has an actual awning rail width of 169" for a 1" overhang. |

As with any flat tow setup, make sure you check your owners manual and follow all of the steps in the recreational towing section. Do you plan to install this yourself? | I have a 2025 Ford Ranger. I want to set it up to flat...

That you have the Curt Wiring Harness with 4-Pole Flat Trailer Connector, # C56225, is the first needed step. If you have not already installed this, please note the linked installation video below for assistance. | I recently...

What do you I need to make this work. My RV has 4 pin flat. | Custer Wireless LED Tow Bar Light - Weatherproof - Magnetic Base - 23inch Long - 4-Pin Round Item # LIW-LDTL I did not realize this is sold with a 4 pin round connector....

Just make sure you follow all the steps and procedures listed in your owners manual. | I need verification on the base plate for the 2025 Ford Ranger. Does that fit the Raptor series and please verify the 2025 Ford Ranger...

Once this is done you will just follow the original pairing steps again as outlined in the instructions manual (and also attached below) to set it as the rear camera. | I have a Furrion vision S observation system. I hooked...

I want to set it up to be towed behind RV. | Do you have a kit that will work with a 1989 ford ranger? I want to set it up to be towed behind RV. | We can help you with the items you'll need to flat tow your 1989 Ford Ranger...

The simplest troubleshooting step is to substitute either a different tow vehicle or a different trailer to see if the same problem occurs. | I have a 2009 Nissan Frontier, and when I connect my trailer using a 4 prong plug...