How To Transition A 2021 Grand Design Reflection 278BH To Electric Over Hydraulic Disc Brakes
Hi I have a 2021 Grand Design 278BH 5th wheel 34. I am looking at what parts I would need to upgrade the brakes from electronic drum to disk. I know the axles are dual Dexter 5,100lbs units. Are you able to point me in the direction of which...
Determining Correct Nev-R-Lube Bearing
I have a 2010 Jayco Designer 32RLTS. How do I determine which nev r lube bearings I need? | Too determine the correct Nev-R-Lube bearing, use a digital caliper like # PTW80157 to measure the inside and outside diameter of the bearing. We offer...
Trailer Right Turn Signal Not Working when Connected to a 2004 Chevy Suburban 2500
When I connect my trailer wire to my truck all trailer lights work except my right turn signal on the trailer only? I dont have any power to the connector plug or the dark green right turn wire. I started to pull the complete 7 wire harness...
Prodigy P3 Brake Controller # 90195 Installation Using Harness # 3024P for 2015 Ram 1500
have this harness but do not have any brake feed power in truck plug for brake controller how do i find it or turn it on | Your 2015 Ram 1500 uses multiplex wiring which operates with very low current and if you are using an incandescent light...
Recommended Trailer Hitch For 2004 Ford Escape
Hello, I am looking for a Class I frame rail mount style for my 2004 Ford Escape. Do you carry such an item? Regards | The Class l trailer hitch that is designed to fit your 2004 Escape is part # C11106. This is a Class l and it has a 1-1/4...
Initial Adjustment Of Self-Adjusting Electric Brakes On Trailer
DO YOU HAVE TO BACKUP AND PUT ON THE BRAKES TO AJUST | To initially adjust the brakes, you will need to raise the trailer and secure it on adequate capacity jack stands. Check that the wheel and drum rotate freely. Do not lift or support trailer...
Troubleshooting Brake Controller Installation When Brakes Lock Up
Just installed tekonsha p3 set the controller all the way to 0.0 and trailer brakes still lock up what could be wrong??? | It sounds like you have the red wire from the brake controller attached to the wrong wire on the stoplight switch. It...
Brake Controller Display Shows Changing Numbers when Not Using the Brake Pedal
Hi Why are the numbers changing when Im driving. Its going up and down between 0.0-2s when Im not even braking | There are a couple of reasons that the brake controller display changes when you are not braking but they are related to a short...
How Are Brake Magnets Affected if Breakaway Cable Has Been Pulled for an Extended Period of Time
My grandson pulled the safety brake cable out about 2 weeks ago.I just saw it today. will it hurt the magnets. The magnets have been hot for 2 weeks | Breakaway Batteries are supposed to be able to send enough power to activate the trailer brakes...
Right Tail Light Not Working on Trailer With New Light and 7-Way Connector
New lights and connector on 7 pole trailer, cleaned all mounting bolts prior to installing. Only getting 2 Amber and left tail lights to light. Blinkers working fine. Cant get right tail light to work when plugged in to tow truck. Does light...
Finding Reverse Light Circuit of 2017 Lexus RX 350 for Install of 5-Way
Where is the back up light wire accusable on the 2017 Lexus RX 350 so the fifth wire on the flat connector can be connected? | Since the reverse lights of your 2017 Lexus RX 350 are in the rear hatch what you'll need to do to track down the...
Replacement Trailer Brakes and Hub/Drums For a 1973 Airstream Argosy 26D Travel Trailer
I need to replace the original electric brakes on a 1973 Airstream Argosy 26 D. The wheels have 6 lugs. Everything is original, so I would like some advice as to what needs replacement and how much will it cost? Any advice would be greatly appreciated!...
Trailer Brakes Not Strong Enough To Stop Trailer
I have a 19’ ram with factory break controller. Gain of 0-10. I have 11.8 volts at truck plug and 11.7 volts at the axle when not connected to magnets. When I connect the break magnets it s to 6.2ish. I have two axles but just one with brakes....
What Wire Should The Red Wire From Redarc Brake Controller Connect on 2022 Toyota Sienna?
Have you any info on where to pick up the brake signal for connection to A Redarc brake controller on my 2022 Sienna Hybrid? I bought the trailer hitch, Redarc controller and related wiring from E-Trailer. Everything is installed, the only thing...
Troubleshooting A Fogatti Tankless Water Heater Controller That Won't Turn On
The remote control will not turn on | If the wall remote for your Fogatti RV Tankless Water Heater # LSB64FR won't power on then you'll want to check to make sure that the fuse on the main unit is blown and that the switch next to it is in the...
No Brake or Turn Signal Lights Working on Trailer
I have running lights but do not have left or right turning lights. Also, don’t have brake lights. Used the stick test and the brake light blade only read 1 volt. I had 13 volts on running lights and the blade for power was reading properly...
How to Test a Trailer Breakaway System for Function
I went to get my trailer big Tex inspected they pulled the pin on the break away u can spin the wheels they changed the battery and the break away the wheels still spin with the new break away what can I do now I checked under the trailer for...
Troubleshooting Both Turn Signals Coming On with Just Left or Right Activated
I hooked up everything right,but when I turn on left or right blinker ,both lights blink at same time.what to do fix problem | If both turn signals are turning on with just the left or right signal activated on the tow vehicle, this means that...
Troubleshooting Trailer Brakes that Lock Up When Connected to Trailer
I have your breakaway box without charger. After a soaking rain the brakes locked on the trailer. Upon inspection, I found a crack in the breakaway switch cover. Thinking water had gotten into the switch, I cut both wires going into the switch....
Can Trailer Wiring Function be Tested without Trailer Connected
Have a 2014 Ford F-150 4x4. Can i test the lights , brakes, and turn signals without hooking up the truck to the Motor home or does the MH and tow truckhave to be grounded together by way of the tow bar assemble. Plug up my wiring cable from...
Replacement 7-Way Trailer Connector for a 2010 Toyota Tacoma
My factory connector needs to be replaced. What model do I need? | If you remove the factory 7-Way (if you haven't already) does the wiring harness that plugs into the back of it have a round connector or square? If it is round, you could use...
Finding the Stop Light Switch Wire on a 2014 Volvo S60
Volvo s60 brake control wire. Where is the location of this wire on the Volvo? | Typically the location of the stop light switch is up and behind the brake pedal but you would need to use a circuit tester like part # PTW2979 to verify which...
How to Identify Replacement Hub Based on Bearing Part Numbers and Spindle Dimensions
I have a broken hub on an old 4-wheel 1000-gal. water tank. Dexter Trailer Idler Hub Assembly for 3,500-lb E-Z Lube Axles - 5 on 5-1/2 Item # 84555UC1-EZ is close, but my spindles are 1.375 x 13/16, not 1. The bearings are fairly new, so...
Seal Recommendation for 5th Wheel Trailer with 5,200 lb Axle
need wheel seals for my 5th wheel i pulled the wheel and spindle off to see the number on the seal but did not see any numbers. | You will want to measure your spindle to make sure (see accompanying photo) but the double lip grease seal that...
Filter Your Search
Contact and Help