Replacement Tarp for Extang Trifecta Signature 2.0 on a 6 Foot Bed 2011 Suzuki Equator
Is there a replacement tarp available for this? Looking to replace my dads leaking Trifecta 2.0 signature tonneau cover for his 2011 Suzuki Equator 6 foot bed. Thanks! | The correct replacement tarp for the Extang Trifecta Signature 2.0 Soft...
Does the Trailer Wiring Harness # 56087 Require the Factory Tow Package on a 2011 Suzuki Equator
Does this part require the factory tow package wiring prior to installation to work? | The CURT Custom Fit Trailer Wiring Harness, item # 56087, does not require the factory tow package for installation. This harness plugs inline with the existing...
Troubleshooting Non-working Running Lights on a Trailer Being Pulled by a 2012 Suzuki Equator
2012 Suzuki equator 4wd. It has trailer oem trailer wiring and I plugged in the wiring harness from U-Haul but I do not have running lights. I have turn signals, emergency flashers and brake lights but no running lights. I have been using...
Transmission/Engine Oil Cooler Recommendation for a 2009 Suzuki Equator
Im looking for a heavy duty trans cooler for Suzuki equator 09 with v6. Same as a Nissan frontier. Also, is there a combo oil and trans cooler that would work. thanks | The best way to pick out a transmission cooler is to measure the area in...
Are Relays Needed to Activate Tow Package Wiring in 2012 Suzuki Equator
For the 2012 suzuki equator, I already have the 4 pin connector attached in the rear, but I dont recall installing a relay kit inside the truck. I havent had to use it yet, however in am picking up a new trailer during the week. I hooked a test...
Ball Mount Recommendations for a 2011 Suzuki Equator
which is the common ball mount for this truck. | The recommended ball mount for the hitches for the 2011 Suzuki Equator is a Ball Mount # AMSC2. The etrailer.com Ball Mount Kit # 989900 that you referenced includes the # AMSC2 as well as a...
Trailer Wiring Harness on 2012 Suzuki Equator is Not Working
i purchesed a wireing kit # 56087 when installed on my truck as per directions the trailor lights wont work nor the turn signals, for turn signal to work i must take out bulb turn off signal turn back on reinstal bulb and signal will work untill...
What is the Length of the Suzuki Trailer Hopkins Wiring Harness part # HM43575?
How long is the wiring end to end on this item? Item # HM43575 | The Hopkins wiring harness item # HM43575 has a length of 45-1/4 inches for the wiring alone and the overall length including the plugs/adapters end to end is 48-1/8 inches. |
Will Curt 26x41 ATV Cargo Carrier Work On Yamaha Beartracker 250
Will the C18101 rear cargo rack fit a 2001 Yamaha Beartracker 250? | The Curt 26x41 ATV Cargo Carrier part # C18101 will fit the 2001 Yamaha Beartracker 250 as long as it has the factory rack on the back. I looked up photos of the Yamaha Beartracker...
Will the Curt Wiring Kit # 56087 fit on a 2011 Suzuki Equator without Tow Package
I would like to know if part #56087 will work on my 2011 Suzuki equator which I believe does not have a tow package. Ive attached a picture of what i believe is the connection and can you tell me if this is where it plugs into. want to make...
Dimensions of Putco Tailgate Cap 51614P
what are the dementions of this part #p51614p I need length and width to make sure it fits | I reached out to the manufacturer and the Putco Tailgate Cap - Stainless Steel # P51614P measures 50.25 inches long. He didn't have a width and we...
Back Up Alert Recommendation for a 2010 Suzuki Equator with a # 921 Reverse Lamp Bulb
Will it fit my 2010 Suzuki Equator Nissan Frontier existing bulb #921 18vots | The Hopkins Backup Alert, # HM20101VA, is designed to replace a # 3156 bulb and will not replace the # 921 bulb on your 2010 Suzuki Equator. Instead, I would recommend...
Replacement Wire Rope Recommendation for Superwinch LT2000
Good Morning what is the correct part number for a replacement winch wire rope for a Super Winch LT-2000? is there a Synthetic Rope available for this model? Thanks, | The Superwinch LT2000 winch has a 50 foot long wire rope with a 5/32 inch...
Picking Out 3,500 lb Trailer Axle Leaf Springs for 2002 Bear Single Axle Trailer
I have a 2002 bear single axel trailer with a 3500 lbs capacity. Is there any chance you can help me figure out what leaf spring I need? I can supply the vin if needed. | What you'll need to do is measure your current springs without the weight...
Recommended Trailer Hitch for a 2001 Honda S2000 to Tow a Motorcycle or Jetski
I am looking for a trailer hitch for a 2001 Honda s2000 to tow a motorcycle or jetski on trailer. What do you recommend for this vehicle that is easy to install prefer no drilling or welding and that is the most hidden, so as to not ruin the...
Curt Trailer Wiring Harness Recommendation for a 2011 Suzuki Equator
how can I tell if my suzuki equater will accept the118263 harness? I DONT KNOW IF IT HAS THE TOW PACKAGE. | The Curt Custom Fit Vehicle Wiring # 56087 that you referenced will work on your Suzuki Equator even if you do not have the tow package....
Trailer Hitch and Wiring for a 2000 Honda S2000
Do you have an installation manual for the hitch its a 2000 honda s2000 | Yes, installation instructions for Curt trailer hitch # C11212 (no longer available) are linked on its product page, right hand side of the page. I have also included...
Tap To Clean Weld Nuts Inside Frame On a Suzuki Equator
the holes in my frame are very rusty, I guess I need a12m x1.25 tap to clean them up. do you sell them? | Yes, we have the 12 mm x 1.25 Tap and Drill Bit part # PTW8662 which can be used to clean the weld nuts inside the frame when installing...
Trailer Wiring Recommendation for a 2012 Suzuki Equator
will this product fill 2012 Suzuki equator without towing package? | We do have a wiring harness designed for your Equator but I spoke with my contact at Curt Manufacturing and found that the custom fit wiring, # 56087, is not recommended for...
Where Does a Trailer Hitch Install on a 2003 Honda S2000
I am hoping to verify that this hitch is mounted to the frame. | The Curt trailer hitch # C11212 attaches to the frame of the 2003 Honda S2000 in 2 places and to the trunk pan in 4 places. I have linked the installation instructions that show...
Trailer Brake Lights/Turn Signals Not Working when Connected to 2009 Suzuki Equator
I just bought the recommended wiring harness from etrailer for my pick up truck that included all the relays to match my pickup. I did the install and made sure everything snapped into place. When I hook up the trailer new trailer the running...
Comparing Curt Wiring Harnesses for a 2011 Suzuki Equator
2011 suzuki equator without trailer package. so my reading notes i would need the #56087 wiring harness. what is the different in #56087 and C56225 harness. thanks | The Curt trailer wiring harness, # C56225, works and installs more like the...
Parts Needed to Install 7 way Connector on 2009 Suzuki Equator
I have a 2009 Suzuki Equator 2wd 6cyl. Years ago I installed a 4pin trailer harness which included the harness that is installed in the passenger side panel. Im needing to install a 7pin adapter to pull an RV, do I need to replace that harness...
Troubleshooting Trailer Brakes that Lock Up when Trailer Wiring is Connected
Help. 7 way connector works well except it applies brakes as soon as it is plugged in 2012 Suzuki Equator sport 4 door 4wd Curt venturer trailer brake shows single green light when brake is touched or manual slide moved, whether trailer plugged...
Filter Your Search
Contact and Help