Troubleshooting Hitch Bolts Not Fitting Weld Nuts on 2006 Pontiac Torrent
2006 Pontiac Torrent. The four bolts that go on outside dont fit into the hole. I sprayed it and cleaned it the best I could and cant get the bolts to thread. The two on the bottom middle fit with some resistance. Do you have any suggestions...
Finding Installer for Curt Hitch on 2009 Kia Rondo
A Curt Trailer Hitch Receiver for a Kia rondo 2009 what car brands aré compatible to install the tráiler Hitch | Hey Adrian, I attached a link to an installer locater that you can use to find someone to install the Curt hitch part # C11031 on...
Parts Needed to Add Brakes to 1992 Coleman Arcadia Pop-Up Camper
I want to add brakes to my 92 Coleman Arcadia pop-up. I am looking for the correct hub/drum and electric brake assemblies. The wheel bolts are 5 on 4 1/2 and the tires are Carlisle USA Trail 20.5x8-10. The current axle includes a square flange...
Bolt Size for Trailer Hitch Installed on 2006 Pontiac Torrent
Hi I was just wondering what size bolt I need for installation of a hitch on my 2006 Pontiac Torrent | For the hitches we offer that fit your 2006 Pontiac Torrent like the etrailer part # e98865 the size hardware that comes with it is M12-1.75...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
Two Front M12 Bolts Will Not Tighten with etrailer Hitch e98865 On a 2007 Pontiac Torrent
I had two problems with this install. The two weld nuts under the license plate never torqued down. They were the only ones that I could tighten easily, but they never tightened up to the proper torque level. Second problem, the rear bolts...
Replacement 1200 Pound Dutton Lainson Brake Winch
I have a Shorestation Jetski lift that Im told uses a 1200 brake winch. The current one has the DL logo on it. Would this unit be the correct replacement? Picture attached. | It isn't exactly the same, the housing design has changed, but...
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
Trailer Hitch Recommendation for a 2007 Kia Rondo
I am looking for a trailer hitch for a Kia Rondo that was manufactured in Dec, 2006. I dont see one in your listing earlier than 2007. Thank You | That is because you most likely have a model year 2007 Kia Rondo that happened to be built in...
Which Brake Switch Wire on 2008 Pontiac Torrent to Connect to Tekonsha Voyager Brake Controller
I purchased this controller from you for my 2008 Pontiac Torrent. I am having a problem with finding the wire on the brake switch that goes hot when the brake is applied. The break pedal wire did not light up my 6 to 12 volts tester. I assume...
Reese Brakeman 83501 Only Sends Power to Trailer Brakes When Using Manual Over Ride
I have installed this unit on a 2007 Pontiac Torrent. The instructions say to attach the red wire to the cold side of the brake pedal switch. On this vehicle the brake pedal switch has 3 wires. The grey wire is always hot 12v. The blue wire...
Aero Bar Rhino Rack Roof Rack that Fits 2009 Volkswagen Rabbit 5 Door Hatch
Hello, I am looking at RR56RR for my 2009 Volkswagen Rabbit 3 door. Your site says it will fit but when I use the part number RV0230B into rhino racks site it states its only for the 5 door car. Which is correct? I really want these for my...
Troubleshooting Wiring Harness # C55560 When Installing on a 2006 Pontiac Torrent
installed in my 2006 torrent power getting to the end of wire but nothing to trailer .trailer lights working fine how do I get them to work ? | The first place I recommend checking is making sure the ground connection is good on the wiring harness,...
Troubleshooting Turn and Brake Lights not Working with Running Lights on, 2009 Volkswagen Rabbit
I have the same problem than the VW GTI guy. After I have wired the kit according to the 2-wire method into my 2009 Rabbit, turn and stop light are working as long as the running light is not on. I have tried also the different 3-wire methods...
Wiring Harness With Easy Install For 2009 Kia Rondo
I am interested in the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector for a 2009 Kia Rondo. One of the issues I see in the reviews is that the green wire from the drivers side to the passenger side can be too short....
Recommended Trailer Hitch Receiver for 2011 Kia Rondo
I am looking for a trailer hitch for my KIA Rondo 2011. Do you guys have anything for this models Thanks | For a trailer hitch that fits your 2011 Kia Rondo we have the Draw-Tite Trailer Hitch Receiver # 36525. This is a custom fit Class I...
Bike Rack Recommendation for a Camplite Trailer with an Aluminum Bumper
I just purchased the Camplite model trailer with a 2x4inch aluminum bumper. Looking for a two bike rack than will fit my conditions. | Since your Camplite Trailer has an aluminum bumper there really isn't a bike rack available that can attach...
Hitch and Bike Rack Recommendation for a 2009 Volkswagen Rabbit
Hello Looking for bike rack. Drive 2009 VW rabbit. Want simple rack, easy use, no scratch car, two adult bikes 1 womens. Thinking of getting hitch. Sort of new to biking. Dont want to spend a ton of money, but also dont want to worry about...
Replacement Wheels/Tires for 1999 Haulrite Jet Ski Trailer
I have a 1999 Haulrite trailer that holds 2 jet skis. I need some replacement tires/wheels. The one good wheel is a newer Dexstar 17-227 with a Loadstar DOT 2QB5 U12 tire. I think that means is a 2012 tire. I am planning to get 2 new wheel/tires,...
Recommended Hitch and Related Items for 2009 Kia Rondo V6 Towing Camper Trailer
What would be best hitch/towing set up to order from you guys for a 07 to 09Rondo V6 with a view to owning a camper trailer? Would a transmission cooler enable higher tow loads? I have not bought the Rondo yet. ..still looking. She will be used...
Filter Your Search
Contact and Help