Result: knobs

When installing a new spring bar, you basically just set the "knob" end of the spring bar into the socket on the ball mount. | How to properly install a draw tight 1200 lb sway bar for toy hauler | Hello Todd. When installing...

Otherwise, if you're needing to ADD 4-Way and 7-Way sockets then you need the following parts: - Curt T-Connector Vehicle Wiring Harness # C58DR - Universal Installation Kit # ETBC7 - No-Drill Mount Bracket, Long # 18136 - Extra 10 Gauge Wire # 10-1-1 (on an as-needed basis) If you also need a brake controller then I really like the Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness # RED52VR because it can be installed virtually anywhere and the control knob doesn't take up much space. This will splice in to the wiring you ran for the ETBC7. |

Pro Tip: Spay some lubricant like WD-40 or PB Blaster on the rubber isolators to make it easier to remove the hanger knobs. | I purchased the replacement CURT trailer hitch hardware from eTrailer for this hitch and installed...

Redarc Tow-Pro Liberty Brake Controller # RED52VR is a proportional brake controller with a small dash mounted control knob for a clean, factory look. What type of trailer are you planning to tow? | I need to install a trailer...

It installs behind the dash, and all you see is the small LED control knob. It will install using the included universal pigtail. | I installed the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector with my receiver...

The on-demand hot water and ability to set the temperature to a specific degree instead of the old fashioned arrow knob will make camping much more enjoyable. The # FR98SR has the following requirements to properly operate: 12VDC Power Input. 7.2-65PSI water Pressure (40-50PSI recommended). |

This mounts out of sight with only the control knob visible in the cab of your vehicle. I have attached some review and installation videos below for your reference. | I want to add brakes to my 92 Coleman Arcadia pop-up....