How to Determine Bolt Hole Pattern of 13" Wheels on '60s Serro Scotty Trailer
Trying to figure out what bolt patter i have on a early to mid 60s scotty serro the rims are 13 inch | There are a few ways to determine what bolt pattern you have on your '60s Serro Scotty trailer wheels with the most common being that you...
Does the Derale 10 inch Electric Fan # D18910 Run Off 12 Volt Power
I am think of using this for another project, are these fans run off of DC power? | Yes, the Derale 10 inch Dyno-Cool Curved-Blade Electric Fan # D18910 that you referenced is designed to work on 12 volt DC power. |
What Ignition-Controlled Circuit in 2001 Mercury Mountaineer Can Trigger Battery Isolation Solenoid
Do you have a wiring diagram how I can connect this to my 2001 mercury mountaineer? I just need to know where I can tap in to the ignition source.. | The simplest method to gain access to an ignition-controlled power circuit in your 2001 Mercury...
How to Install a Brake Controller on a 2008 Mercury Mountaineer
I have a 2008 Mercury Mountaineer. It is factory wired with a 4 pole flat connecter at the hitch. I want to install part #37185 so I can utilize the brakes on my camper. I have located the connector for the brake controller beneath the dash...
Will The Curt Trailer Hitch Receiver C12232 Fit a 2001 Mercury Sable Station Wagon?
Will #C12232 fit a 2001 Sable Station Wagon? I don’t see anything about wagons. | Yes, the Curt Trailer Hitch Receiver # C12232 is compatible with your 2001 Mercury Sable station wagon as well as the sedans. This will only fit on models with...
Can Timbren Axle Less Systems be Used on Tandem Axle Trailers
can I use a Timbren Axle-Less Trailer Suspension System w Hubs - Straight Spindle to convert a single axle to tandem | You can use Timbren Axle-Less Trailer Suspension Systems like the part # A35RS545 in a tandem axle setup but I would not recommend...
Parts Needed For 7-Way & Brake Controller For 2003 Mercury Mountaineer
NEED ELECTRIC BRAKE WITH 7 PIN FOR 03 MOUNTAINEER | Sure thing, we can get your 2003 Mercury Mountaineer set up with a 7-way and brake controller. The first thing you will need is a 4-way if your Mercury doesn't have one, and then you'll plug...
Recommended Trailer Hitch and Towing Accessories for 2008 Mercury Mariner w/ Backup Sensors
What trailer hitch can I install on my 2008 Mariner which has backup sensors? | The presence of the back-up sensors will not have any bearing on the installation of a hitch. The Curt # 13650 would be an excellent choice that would work well...
Comparing Lippert Trailair Cushioned 5th Wheel Pin Boxes LC155933 and LC158777
what is the difference between LC155933 and LC158777? | The two Lippert Trailair 5th wheel pin boxes LC155933 and # LC158777 are actually one and the same part. The old part number LC155933 has been replaced by the new item reference # LC158777....
Trailer Wiring Replacement Recommendation for 2002 Mercury Mountaineer
I have a factory tow package installed but the relay box in the rt. 1/4 panel is missing the wiring that the relays should plug into. The plug at the hitch is a 7 plug round and the harness is factory stock. verified by dealer Have you ever...
Is There Anywhere to Avoid when Drilling Roof of 2005 Mercury Mariner to Mount Roof Rack Tracks
Before I begin drilling, are there areas in which I should NOT drill? I just a bit nervous about this drilling thing. | If your 2005 Mercury Mariner has side curtain air bags then you will want to install tracks # THTP54 further in (towards...
Will the Thule Trunk Mounted Bike Rack TH910 Fit a 1992 Mercury Tracer
I have a 1992 Mercury Tracer, will your 2 bike rack fit my car? | Yes. The Thule Passage 2 Bike Carrier Trunk Mounted Bike Rack, # TH910XT, will fit your 1992 Mercury Tracer as long as it is the 4 door sedan model. The # TH911XT will also fit....
Can the 4-Pole Hardwire Kit with Converter 119178KIT be Used With a Trailer With LEDs
will this part work if the trailer has LED lights, but the car doesnt? | Yes, the 4-Pole Hardwire Kit with Converter (Includes Tester), # 119178KIT, will work. It will work with LED lights on the trailer and/or on the tow vehicle. |
How to Install a 4 Pole to 5 Pole Adapter for Adding a Reverse Light Circuit
If I add a 4 pole to 5 pole converter for trailer back up lights/reverse brake release, does the extra wire from the converter connect to either of the two back up lights? If so, which wire? There are two wires into each back up bulb socket....
The Correct 4-Pole Hardwire Wiring Kit and Installation Instructions for a 2004 Mercury Sable
Will this work on my vehicle -seems there are so many bulbs I was curious whether this is the one would work | The 4-Pole Hardwire Kit, # 20250 is similar to the product you need but it is not quite the right one. The wiring harness for your...
Are Specific Locks Able to be Keyed Alike and Also Have a Unique Key No One Else Has?
I get it the keys can be keyed alike. However Im looking to spend a lot of money to replace all my brand new locks that came on my brand new Thor coach BECAUSE their locks/keys are common ones that other coach owners have as well i.e. I could...
Trunk Bike Rack Recommendation for 1999 Mercury Cougar With a Spoiler
Will this product fit my 1999 mercury cougar? It has a spoiler. | My technical contact at Hollywood Racks confirmed that the Hollywood Racks Expedition 2 # HRF6-2 will fit your 1999 Mercury Cougar with your spoiler. I have attached a brief...
Parts Needed to Add Brakes to Aluma 6310H Trailer
I have an Aluma 6310H trailer. I want to add electric brakes. Based on my vin they gave me the following measurements: Lippert axle, grease seal 122087, inner bearing L68149, Outer bearing L44649, Inner race L68111 Outer race L44610. Do you...
Installing a 7-Way Trailer Connector on a 2011 Mercury Mariner
I am looking on where I connect my other wires to a 2011 mercury mariner because I am hooking up a wiring adapter for a 4 prong to 7 prong. I have the 4 prong installed and need the 7 for the pop up trailer that has electric brakes. | On the...
Hitch and Wiring Harness for 2007 Mercury Mariner
I was thinking about buying and installing a trailer hitch on my 2007 mercury Mariner premier suv 4x4. I want the Hidden Hitch class 3 receiver and was wondering if you could tell me the part number I would need and also tell me what wiring...
Can Ultra-Fab Hitch Motorcycle Carrier Hold Ninja 300 Motorcycle on 2009 Mercury Mariner V6
Will part# SMC600 work for carrying a Ninja 300 with a Reese 44680 class 3 hitch? | The Draw-Tite and Hidden Hitch Class III hitches we offer for your 2009 Mercury Mariner have tongue weight (TW) ratings of 525-lbs. Both of these are sister...
Will the Edge Insight Display Transmission Fluid Temperate on a 2003 Mercury Marauder.
Will this device monitor my transmission fluid in 2003 Mercury Marauder, without a adding a probe, or can I pull that data off the OBD2 port. | The transmission temperature on your 2003 Mercury Marauder should run through the computer and be...
Parts Needed To Install Yakima Space Case On 2004 Mercury Mountaineer What
Hello- I have a 2004 Mercury Mountainer-V8. What do I need to mount a Yakima Space Case on top of vehicle? | All you need to install the discontinued Yakima Space Case on your 2004 Mercury Mountaineer is crossbars with 30" to 36" spacing between...
Exhaust Hanger Touching Hitch and Transferring Vibration and Noise through a 2010 Mercury Mariner
I installed this a couple days ago. One issue, is that when at idol in R or D, the muffler dampner hits the assembly and the vibration inside a little loud. If I move the hitch over, it will no longer be centered. Any suggestions? 2010 Mercury...
Filter Your Search
Contact and Help