Where Does the 1/2" Bracket Strap on Firestone Air Bags for 1965 Ford F-350 Go
I have a 1999 7.3 f350 with 1 overload spring. Does the lower mount ,using the 7inch bolt , mont to the overload spring or the whole spring pack? It says both ways. | In regards to the Firestone Ride-Rite Air Helper Springs part # F2071 on a...
Class V Trailer Hitch Availability For A 1970 Ford F-250
Looking for a 15800 Curt tow package for my 1970 f 250 pichup | I do have some solutions for your 1970 Ford F-250, however, the Curt Trailer Hitch Receiver # C15800 you reference is not a fit for your truck. If your vehicle has the deepdrop...
Recommendation To Cover Hitch Ball Holes On Westin Fey Diamondstep Rear Bumper # 20002-92230
I just ordered, received and installed the step bumper part 20002-92230, and I am EXTREMELY pleased with it I have submitted a review that hasnt published yet. I dont intend to install a hitch on the truck, its a 15-year-long restoration that...
Is the LCD Display on the Tekonsha Prodigy P3 Included in the Warranty
Does the lifetime warranty cover the LCD display going bad and bleeding in from the sides? Who covers the warranty, the seller or the mfgr? Thanks, | I spoke to my contact at Tekonsha and they said the LCD display on the Tekonsha Prodigy P3...
Diameter and Thread Pitch of Wheel Stud on AxleTek AKIHUB-545-35-G-EZ-K Trailer Idler Hub
for TDE Trailer Hub Part 46210 | The AxleTek # AKIHUB-545-35-G-EZ-K hub you'd looked at uses 1/2 inch-20 wheel studs. 1/2 inch diameter, 20 threads per inch. The lug nuts are included with the hub, as are the bearings, races, grease seal and...
Demco Fifth Wheel Rail Kit that Fits 1977 Ford F-350
I have a 1977 Ford F350, single cab and chassis no bed, 2wd truck that I need rails and brackets to install a Husky EZ roller hitch that I already own. Will DEMCO DM8552005-71 work for this truck/hitch combination? Does part number DM8552005-71...
Why is There Only One Ground Wire on the Adapter 4-Pole to 7-Pole and 4-Pole Part # 37185
On part #37185 why is there no ground wire coming off of the Four flat connector that plugs into the existing 4 way? Is the single white wire the ground for both the 4 flat and 7 round? If so can i use the part #40105 T connector in my wiring...
Pace Edwards Tonneau Cover that Fits 1968 Ford F-100 Long Bed
I have a question regarding the item #311-JRF1290. It states that this item will fit onto a 1968 f100 Long bed, but I was wondering what the dimensions for the cover are for my year of truck so I know for sure it will fit before purchasing |...
Comparing White 16" 8 Hole Dexstar Steel Spoke Trailer Wheels AM20750 and AM20768
What is the difference between AM20750 Dexstar steel white spoke and AM20768 Dexstar steel white spoke? | The Dexstar Steel Spoke Trailer Wheel part # AM20750 is the standard duty 3,750 lb capacity and the Dexstar Steel Spoke Trailer Wheel part...
Installation Kit Required To Install Westin Fey Surestep Bumper On a 1973-1978 Ford F-250
What installation kit is required for a 1973-78 ford f250? Westin Fey Sure step Bumper. | The Installation Kit # 92230 is the kit you need to install one of the Westin Fey Surestep Bumpers # 20022, # 21002 or # 21007 on your 1973-1978 Ford F-250. |
Distance Between Vertical Mounting Flanges of Curt Hitch C15300
what is the inside measurement between the vertical flanges of this hitch? need to know the total measure to make sure my fuel tank fits between them. Thanks | I checked with Curt and the distance between the vertical mounting flanges of the...
How to Measure for Trailer Hitch Clearance on a 1963 Ford F-100 With a Rear Barden Bumper
I am looking for a Class III receiver to fit the subject vehicle I want to keep the bumper. Will the 41001 hitch clear the barden bumper? What measurements would I need to ensure that there is no interferance. | When mounted, the top of the...
Replacement Vent Lid for Older Heng's Vent Cover
I have a late 60’s Aristocrat/pickup partner. I need two replacement vent covers. Do you have a vent that you would recommend? The previous vents were made by Heng’s Industries. Thanks so much for your help. | We do have one option we know will...
Is There a Trailer Hitch for a 70s Ford F-250 with Flatbed
My 1972 Ford F250 is a Flatbed truck. Do you sell a trailer hitch for my truck? If you do I would like to buy one and everything else that goes with it. Thank you very much. | We do offer trailer hitch options for a 1972 Ford F-250 but as...
Trailer Hitch and Wiring for 1970 Ford F-250
Id like to use this hitch and want to make sure i order everything ill need to install, as well as wiring. Can you recommend which wiring system and if any mounts are needed? | The B and W Trailer hitch part # BWHDRH25122 that you referenced...
Bolt Hole Spacing Drivers Side Frame Rail to Passenger Side Frame Rail B&W Heavy Duty Receiver
left to right hole spacing with hitch configured for 34inch frame | The Hole spacing for the B&W Heavy-Duty Trailer Hitch Receiver # BWHDRH25198 are as follows(all measurements are for center of hole to center of hole). 34" Width Frame -Front...
Can Atwood Air Command RV AC Units Replace Dometic Penguin Heat Pumps on 2004 Alpine Coach
I have a 2004 Alpine Coach. It has 2 Dometic penguin heat pumps. The climate control center has 5 buttons, and it also controls the furnace. This is a ducted system with return on the ceiling kit and ducts running fore and aft. I would like...
Engine Block Heater for 1982 Ford F150 w/ 5.8L V8 Engine
In Kats Catalog it say that this heater should fit numerous older vehicle, including my 1982 Ford F150 with a 5.8L V8 engine. Yet in multiple places online Amazon this heater is said not to fit. I have attached a screenshot of the PDF. | Kat's...
Dimensions of Hub Arms for a Rock Tamers Mudflap
How long is the Hub Arm for Rock Tamers Heavy-Duty, Adjustable Mud Flap System ?? | I went and grabbed a # ERT039 from our warehouse and found that from the very top to the very bottom it measures 7-1/4 inches and from the center of the holes...
Custom Fit 5th Wheel Rails And In-Bed 7-Way For A 1976 Ford F-250
Hi all, very new to towing and I’m considering a 5th wheel hitch for towing a dump trailer on my old beast of a work truck. 76 f250 camper special, 460 with the heavier springs and rear axle. looking at the Reese 16k and it appears as though...
Adapter for 4-Flat on Truck and 7-Way on Trailer
will this connector work for a 7 way on the trailer to a 4 way on the truck | We do have a solution for you, though the Reese Trailer Connector Adapter # 78118 will not work for you. Instead I recommend the Hopkins Endurance Quick-Install Trailer...
Goose Neck Hitch Options for 1975 Ford F250 Crew Cab with 34-Inch Frame
I was wondering if there was any kind of a hidden gooseneck hitch or gooseneck hitch in general for a 1975 f250 crew cab with the 34 inch frame? | There are no direct-fit goose neck hitch options for your 1975 Ford F-250 crew cab. However you...
Parts for Installing Prodigy P3 Brake Controller in 1965 Ford F-100 and 2006 Chevy Avalanche
Im interested in the Tekonsha Prodigy P3 Trailer Brake Controller for use in two vehicles I have. It will be used primarily with a 1965 F100 which does not currently have any trailer tight wiring. Its an old simple four wire tail light system...
What Happens If Reese Friction Sway Control Is Not Level
What happens when the sway bar is not level | It is important to make sure that the Reese Friction Sway Control # 83660 is level when installed. If the sway control is unlevel by a significant amount the slide bar will bind in the main body...
Filter Your Search
Contact and Help