Distance Between Slipper Spring Hangers When Used with Slipper Spring # SP-177275
Published 11/12/2014
Question:
With the slipper spring SP-177275 and bolt on hangers, what is the recommended distance between hangers? Thanks,
asked by: Guy
0
Expert Reply:
The distance from the center of the bolt hole on front hanger to the rear hanger for the slipper spring # SP-177275 would need to be 23-1/8 inches.
I attached an FAQ article on slipper spring suspension systems for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
2-Leaf Slipper Spring w/ Radius End for 1,000-lb Trailer Axles - 24-5/8" Long
- Trailer Leaf Springs
- Slipper Springs
- 9/16 Inch Eye
- Nylon Bushings
- 1000 lbs
- 1-3/4 Inch Wide
- 2 Leaf
- 24-5/8 Inch Long
- Standard Grade
- Universal Group
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: What Kind Of Bushings Does The CE Smith Triangular Equalizer CES86WR Have?
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Picking Out Replacement Leaf Springs for 2001 Coleman Utah Pop Up
- Q&A: Can Longer Crossbars Install on the Malone EcoLight Trailer
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Replacement Slipper Springs for Triton LTWCI Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: 12 Inch Trailer Tire w/ High Load and Speed Rating
- Q&A: Can a Three Leaf Spring Stack Be Used To Replace a Two Leaf Spring Stack
- Article: Trailer Lighting Requirements
- Article: How to Change the Axle on your Boat Trailer Without Leaving your Driveway
- Article: How to Replace Trailer Leaf Springs in 5 Steps