Is Boat Trailer Roller Bracket Available For Rollers That Use 5/8 Inch Shaft
Updated 11/04/2014 | Published 11/03/2014
Products Featured in This Question
Question:
Do you have these same brackets to mount a roller that takes a 5/8inch shaft. Is it possible to drill out hole more to fit a 5/8inch shaft in the bracket for a roller that takes 5/8 Thanks
asked by: Josh
Expert Reply:
The Side Angle Mounting Brackets for Boat Trailer Rollers, part # CE10211G, you referenced have a 3/8 inch hole used for attaching boat trailer roller shafts. Drilling the hole out on this bracket could compromise the integrity of the bracket and would not be recommended.
We do have brackets that may work for you if you have the mounting space available. They are part # CE10500G. The mounting slots on these brackets are 1/2 in wide x 5 in tall.
Product Page this Question was Asked From
CE Smith Side Angle Mounting Brackets for Boat Trailer Rollers - Galvanized Steel - 1 Pair
- Boat Trailer Parts
- Rollers
- Side Angle Bracket
- Galvanized Steel
- CE Smith
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Q&A: Recommended HappiJac Extender Bracket for Dually Trucks
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Difference Between SWC9041-1, SWC9042-1 and 464600 Trailer Frame Wire Clips
- Q&A: How to Install Ground Wire To Trailer Connector on Utility Trailer
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Replacement Axle And Leaf Springs For A 4' x 6' Single Axle Trailer
- Q&A: Dimensions of CE Smith Side Angle Galvanized Mounting Bracket
- Q&A: Recommended Brake Assemblies for Karavan Boat Trailer with 3500 lb Axle
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: How to Install E-Track in 3 Easy Steps
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)