Will Fulton 1200 Pound Swivel Trailer Jack Fit a 2004 Triton 186 PD
Published 10/29/2014 >
Question:
I have a 2004 Triton 186 PD. I need to replace the trailer jack due to the wheel leaning a little. I measured the weld bracket from the top, and the center is 21/2 inches. Is this correct ?
asked by: Joe B
Expert Reply:
The mounting bracket that gets welded to the frame for Fulton swivel jack # FTJ120W0301 is approximately 2-1/4 inches from the top of the bracket to the center of the pilot hole in the middle of the bracket.
It could still potentially work for you if the pilot hole on the bracket you have now is 2-1/4 inches in diameter. The center hole on the jack is 2-1/2 inches. The holes that the jack pin goes through are 3 inches apart on center (up and down and side to side).
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommendation to Replace Shelby 5756A Trailer Jack
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Cost Effective Weld-On Trailer Jack With A Wheel
- Q&A: Replacement Jack for Bulldog Model 130 Marine Jack
- Q&A: Is there a Higher Rated Fulton Jack that Uses the Same Swivel Mount as My TJ120W0301?
- Q&A: Replacement for Fulton Magnum Series Trailer Jack
- Q&A: Replacement Jack to Bolt Up to Shelby 5784 Mounting Bracket
- Article: Best Boat Trailer Jacks
- Article: Trailer Maintenance Schedule
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Lighting Requirements
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Tire Sizing
- Article: 7 Common Questions Everyone Has About Trailer Tires
