Installing the Curt T-Connector Vehicle Wiring Harness # C56343 on 2010 Ford Flex SE

Published 09/23/2014

Question:

The installation instructions look straightforward, but I did not see any information about the controller unit. What/where is the suggested mounting location for the power unit on a 2010 Flex SE? This vehicle was purchased w/o the tow package. Ive installed the factory OEM hitch and looking at this Curt unit to take care of my wiring needs. Thanks for your help in this matter.

asked by: Ben

Expert Reply:

When it comes to installing the Curt T-Connector Vehicle Wiring Harness, # C56343, on your 2010 Ford Flex SE, you will adhere the powered converter box to the frame of the car in the open cavity below the driver's side taillight.

expert reply by: Leah S