Measurements of Snap Ring Used on Bull Dog Swivel Trailer Jacks
Updated 09/11/2014 | Published 09/10/2014
Products Featured in This Question
Question:
Do you know the inside diameter of the snap ring that holds the jack to the bracket?
asked by: Danny
0
Expert Reply:
The snap ring on Bull Dog swivel jack # BD151443 is actually # BD500241 and it has the following measurements:
Inner diameter = 2.28 inches
Outer diameter = 2.65 inches
Width at widest part = 0.25 inches
Thickness = 0.081 inches
expert reply by:
Michael H
0
Product Page this Question was Asked From
Bulldog Round, Snap-Ring Swivel Jack - Bolt On - Topwind - 10" Lift - 2,000 lbs
- Trailer Jack
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Topwind Jack
- 1001 - 2000 lbs
- Manual Jack
- 10 Inch Lift
- Bolt-On
- No Wheel or Foot
- Bulldog
more information >
Continue Researching
- Q&A: Is Hydrastar Actuator Compatible With 2025 Ram 1500 OEM Brake Controller
- Q&A: How To Remove Motor on Kwikee 24/25 Series Electric Steps
- Q&A: Replacement For 1,000 lb Fulton Trailer Jack That is Welded on
- Q&A: Replacement 3/8" Plunger Pin Needed for Atwood Swivel Jack on Boat Trailer
- Q&A: What Is The Weight And Specs Of Rapid Hitch Adjustable Ball Mount AM3411
- Q&A: Replacement For Grease Seal 32374 For Trailer
- Q&A: Spare Wheel and Tire for Aluma Trailer 6310H
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best 2020 1/2-Ton Trucks for Towing a 5th Wheel
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Most Popular Wheel Bearings
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012