Which Wire Goes Where on a Reverse Lockout Solenoid
Updated 09/05/2014 | Published 09/03/2014
Question:
Need to know how to wire the solenoid. On my old actuator, the solenoid only had 1 wire. The new one has 2, Im assuming 1 is ground but they are both yellow wires?
asked by: Garret
0
Expert Reply:
It doesn't matter which wire is used for the power circuit and which is ground. Either wire will do fine. Run one of the wires to your reverse light circuit and then ground the other circuit and you will be good.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Demco Hydraulic Brake Actuator w/ Electric Lockout - Disc - Primed - Adjustable Channel - 8,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Farm Trailer
- Construction Trailer
- Bolt-On
- Weld-On
- 8000 lbs GTW
- Channel
- 3 Inch Channel Tongue
- Disc Brakes
- Electric Lockout
- Demco
more information >
Continue Researching
- Q&A: Which Hardware Kit For Demco Trailer Coupler # DM88XR
- Q&A: Do I Need Different Master Cylinder When Upgrading To Disc Brakes? Demco DA75 Brake Actuator
- Q&A: Dimensions Of Channel On Demco Hydraulic Brake Actuator DM8759422
- Q&A: Should Demco Surge Actuator DM8104002 be Welded or Bolted On
- Q&A: Parts Needed To Convert Demco DA66B Surge Actuator From Drum Brakes To Disc Brakes
- Q&A: Width of Demco Trailer Hydraulic Disc Brake Actuator
- Q&A: DA91 Demco Disc Brake Actuator for 2-5/16 Hitch Ball with Electric Lockout Needed
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Roadmaster Vehicle Specific Base Plates